A Power Re-Use Technique for Improved Efficiency of Outphasing Microwave Power Amplifiers
نویسندگان
چکیده
An improved power re-use technique is introduced for application to outphased microwave power amplifiers. The technique allows a significant portion of the wasted out-of-phase components of the signal to be returned to the power supply, resulting in substantial improvements in overall power-amplifier efficiency. A peak re-use RF-to-DC efficiency of 63% was obtained at 1.96 GHz.
منابع مشابه
OUTPHASING TRANSMITTER An Outphasing Transmitter Using Class - E PAs and Asym - metric Combining : Part
H igh efficiency linear amplification is of great interest in modern communication systems as it increases talk time, decreases power consumption , decreases heat dissipation, and improves reliability. The efficiency of linear power amplifiers (PAs) is highest at the peak output power (PEP) and decreases significantly for low amplitudes, as shown in Figure 1. Signals with time-varying amplitude...
متن کاملPower Amplifiers and Transmitters for RF and Microwave
The generation of RF/microwave power is required not only in wireless communications, but also in applications such as jamming, imaging, RF heating, and miniature dc/dc converters. Each application has its own unique requirements for frequency, bandwidth, load, power, efficiency, linearity, and cost. RF power is generated by a wide variety of techniques, implementations, and active devices. Pow...
متن کاملPower Amplifiers for Next Generation Wireless Platforms
Class-E amplifier has the potential to deliver high efficiency required for the next generation wireless systems. In this journal, we discuss a novel load pull analysis technique to characterize the efficiency performance of Class-E amplifier in an outphasing power combining scheme. Class-E amplifier is not an ideal current or voltage source as is required for the traditional analysis of outpha...
متن کاملNon-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کاملClass-E RF Power Amplifiers
This article is based on “Class-E High-Efficiency Power Amplifiers, from HF to Microwave,” Proceedings of the IEEE International Microwave Symposium, June 1998, Baltimore; and “ClassE Switching-Mode High-Efficiency Tuned RF Microwave Power Amplifier: Improved Design Equations,” Proceedings of the IEEE International Microwave Symposium, June 2000, Boston; both by Nat Sokal, © IEEE 1998, 2000.—Ed.
متن کامل