Numerical simulation of breakup of a viscous drop in simple shear flow through a volume-of-fluid method
نویسندگان
چکیده
A spherical drop, placed in a second liquid of the same density, is subjected to shearing between parallel plates. The subsequent flow is investigated numerically with a volume-of-fluid ~VOF! method. The scheme incorporates a semi-implicit Stokes solver to enable computations at low Reynolds number. Our simulations compare well with previous theoretical, numerical, and experimental results. For capillary numbers greater than the critical value, the drop deforms to a dumbbell shape and daughter drops detach via an end-pinching mechanism. The number of daughter drops increases with the capillary number. The breakup can also be initiated by increasing the Reynolds number. © 2000 American Institute of Physics. @S1070-6631~00!02002-X#
منابع مشابه
Numerical Simulation of Laminar Convective Heat Transfer and Pressure Drop of Water Based-Al2O3 Nanofluid as A Non Newtonian Fluid by Computational Fluid Dynamic (CFD)
The convective heat transfer and pressure drop of water based Al2O3 nanofluid in a horizontal tube subject to constant wall temperature condition is investigated by computational fluid dynamic (CFD) method. The Al2O3 nanofluid at five volume concentration of 0.1, 0.5, 1.0, 1.5 and 2 % are applied as a non Newtonian power law and Newtonian fluid with experimentally measured properties of density...
متن کاملViscous Models Comparison in Water Impact of Twin 2D Falling Wedges Simulation by Different Numerical Solvers
In this paper, symmetric water entry of twin wedges is investigated for deadrise angle of 30 degree. Three numerical simulation of a symmetric impact, considering rigid body dynamic equations of motion in two-phase flow is presented. The two-phase flow around the wedges is solved by Finite Element based on Finite Volume method (FEM-FVM) which is used in conjunction with Volume of Fluid (VOF) sc...
متن کاملLattice Boltzmann Simulation of Deformation and Breakup of a Droplet under Gravity Force Using Interparticle Potential Model
Abstract In this paper interparticle potential model of the lattice Boltzmann method (LBM) is used to simulate deformation and breakup of a falling droplet under gravity force. First this model is applied to ensure that the surface tension effect is properly implemented in this model. Two tests have been considered. First, it has been checked an initial square drop in a 2D domain can freely def...
متن کاملOn the Analysis of Laminar Flow of Viscous Fluid through a Porous Channel with Suction/Injection at Slowly Expanding or Contracting Walls
The vast biological and industrial applications of laminar flow of viscous fluid through a porous channel with contracting or expanding permeable wall have attest to the importance of studying the flow process. In this paper, two-dimensional flow of viscous fluid in a porous channel through slowly expanding or contracting walls with injection or suction is analyzed using variation parameter met...
متن کاملExperimental Study and Three-Dimensional Numerical Flow Simulation in a Centrifugal Pump when Handling Viscous Fluids
In this paper the centrifugal pump performances are tested when handling water and viscous oils as Newtonian fluids. Also, this paper shows a numerical simulation of the three-dimensional fluid flow inside a centrifugal pump. For these numerical simulations the SIMPLEC algorithm is used for solving governing equations of incompressible viscous/turbulent flows through the pump. The k-ε turbulenc...
متن کامل