Detection efficiency calibration of single-photon silicon avalanche photodiodes traceable using double attenuator technique
نویسندگان
چکیده
A highly accurate method for the determination of the detection efficiency of a silicon single-photon avalanche diode (Si-SPAD) is presented. This method is based on the comparison of the detected count rate of the Si-SPAD compared to the photon rate determined from a calibrated silicon diode using a modified attenuator technique, in which the total attenuation is measured in two attenuation steps. Furthermore, a validation of this two-step method is performed using attenuators of higher transmittance. The setup is a tabletop one, laser-based, and fully automated. The measurement uncertainty components are determined and analyzed in detail. The obtained standard measurement uncertainty is < 0.5%. Main contributions are the transmission of the neutral density filters used as attenuators and the spectral responsivity of the calibrated analog silicon diode. Furthermore, the dependence of the detection efficiency of the Si-SPAD on the mean photon number of the impinging laser radiation with Poissonian statistics is investigated.
منابع مشابه
Ultra-low noise single-photon detector based on Si avalanche photodiode.
We report operation and characterization of a lab-assembled single-photon detector based on commercial silicon avalanche photodiodes (PerkinElmer C30902SH, C30921SH). Dark count rate as low as 5 Hz was achieved by cooling the photodiodes down to -80 °C. While afterpulsing increased as the photodiode temperature was decreased, total afterpulse probability did not become significant due to detect...
متن کاملNew Results on Single-Photon Up-Conversion
The process of up-conversion is shown to enable superior single-photon detectors in the infrared, compared to InGaAs and germanium Avalanche Photodiodes (APDs) (normally used for IR single photon detection). After up-converting an infrared photon to a visible one in a non-linear crystal–Periodically Poled Lithium Niobate (PPLN)–we use a silicon APD to efficiently detect the frequency up-shifted...
متن کاملSingle Photon Counting UV Solar-Blind Detectors Using Silicon and III-Nitride Materials
Ultraviolet (UV) studies in astronomy, cosmology, planetary studies, biological and medical applications often require precision detection of faint objects and in many cases require photon-counting detection. We present an overview of two approaches for achieving photon counting in the UV. The first approach involves UV enhancement of photon-counting silicon detectors, including electron multip...
متن کاملSingle-photon property characterization of 1.3 μm emissions from InAs/GaAs quantum dots using silicon avalanche photodiodes
We developed a new approach to test the single-photon emissions of semiconductor quantum dots (QDs) in the optical communication band. A diamond-anvil cell pressure device was used for blue-shifting the 1.3 μm emissions of InAs/GaAs QDs to 0.9 μm for detection by silicon avalanche photodiodes. The obtained g((2))(0) values from the second-order autocorrelation function measurements of several Q...
متن کاملPeriodically poled lithium niobate waveguide sum-frequency generator for efficient single-photon detection at communication wavelengths.
We present a device to facilitate single-photon detection at communication wavelengths based on continuous-wave sum-frequency generation with an upconversion efficiency exceeding 90%. Sum-frequency generation in a periodically poled lithium niobate waveguide is used to upconvert signal photons to the near infrared, where detection can be performed efficiently by use of silicon avalanche photodi...
متن کامل