Processing benefits of high repetition rate and high average power 355 nm laser for micromachining of microelectronics packaging materials
نویسنده
چکیده
It has been shown that micromachining of polyimide using a mode-locked high repetition rate, 80 MHz, 355nm laser is more efficient than the q-switched laser at same wavelength and same power level in terms of material removal rate. In this study we have explored and characterized the benefits of using high repetition rate, high average power, 355 nm mode-locked and q-switched lasers for micromachining of various microelectronics packaging materials that have different thermal properties. The removal rate and quality of machining have been analyzed against the difference in thermal properties of the material. The implications of the results observed are also discussed from practical manufacturing perspective.
منابع مشابه
Micromachining with a High Repetition Rate Femtosecond Fiber Laser
Industrial micromachining applications with ultrashort pulse lasers are often difficult to make practical due to the lack of robustness of the laser and the slow processing speed resulting from the low repetition rate. In the past, amplified, femtosecond lasers produced high pulse energies, but at a slow pulse repetition rate of around a kHz. The high repetition rate oscillators did not have en...
متن کاملStable, high-power, Yb-fiber-based, picosecond ultraviolet generation at 355 nm using BiB3O6.
We report a stable, high-power, high-repetition-rate, picosecond ultraviolet (UV) source at 355 nm based on single-pass sum-frequency generation of a mode-locked Yb-fiber laser at 1064 nm in the nonlinear crystal BiB3O6. By performing single-pass second-harmonic generation (SHG) in a 30-mm-long LiB3O5 crystal, up to 9.1 W of average green power at 532 nm is obtained at a single-pass SHG efficie...
متن کاملHeat accumulation during pulsed laser materials processing.
Laser materials processing with ultra-short pulses allows very precise and high quality results with a minimum extent of the thermally affected zone. However, with increasing average laser power and repetition rates the so-called heat accumulation effect becomes a considerable issue. The following discussion presents a comprehensive analytical treatment of multi-pulse processing and reveals the...
متن کاملEvaluation of the Influence of the Number of Laser Shots on the Characterization of TiO2/MgO Nanocomposites
The objectives of this work is to synthesize TiO2/MgO nanocomposites using a pulse laser deposition technique. At a vacuum pressure of 2.5 10-2 mBar, TiO2/MgO nanocomposites were synthesized on substrates with a laser power of 600 mJ and a wavelength of 1064 nm. This search utilizes various pulses (500, 600, and 700) at a 6-Hertz repetition rate. X-ray diffraction was utilized to inves...
متن کامل1 J, 0.5 kHz repetition rate picosecond laser.
We report the demonstration of a diode-pumped chirped pulse amplification Yb:YAG laser that produces λ=1.03 μm pulses of up to 1.5 J energy compressible to sub-5 ps duration at a repetition rate of 500 Hz (750 W average power). Amplification to high energy takes place in cryogenically cooled Yb:YAG active mirrors designed for kilowatt average power laser operation. This compact laser system wi...
متن کامل