EXAFS IN CuZn BRASS ALLOYS DURING MARTENSITIC TRANSFORMATION
نویسندگان
چکیده
منابع مشابه
The remarkable activity and stability of a highly dispersive beta-brass Cu-Zn catalyst for the production of ethylene glycol.
Incorporation of Zn atoms into a nanosize Cu lattice is known to alter the electronic properties of Cu, improving catalytic performance in a number of industrially important reactions. However the structural influence of Zn on the Cu phase is not well studied. Here, we show that Cu nano-clusters modified with increasing concentration of Zn, derived from ZnO support doped with Ga(3+), can dramat...
متن کاملMobility of Interphase Boundaries and Hysteresis of Martensitic Transformation in Alloys
A phenomenological description of martensitic transformation is proposed on the basis of such parameters as: a degree of lattice coherency between austenite and martensite phases, mobility of interphase boundaries, elastic energy stored during martensitic transformation and degree of its relaxation. Son),: experimental results confirming the proposed ideas are presented.
متن کاملEffects of Annealing on the Martensitic Transformation of Ni-Based Ferromagnetic Shape Memory Heusler Alloys and Nanoparticles
We report on the effects of annealing on the martensitic phase transformation in the Ni-based Heusler system: Mn50Ni40Sn10 and Mn50Ni41Sn9 powder and Co50Ni21Ga32 nanoparticles. For the powdered Mn50Ni40Sn10 and Mn50Ni41Sn9 alloys, structural and magnetic measurements reveal that post-annealing decreases the martensitic transformation temperatures and increases the transition hysteresis. This m...
متن کاملEffect of the Primary Microstructures during Training Producers on TWSME in NiTi Alloys (TECHNICAL NOTE)
The influence of the martensitic, martensitic+austenitic and austenitic structures in bending training on two-way shape memory effect (TWSME) in Ni-50.8 at %Ti and Ni-49.9 at %Ti alloys was studied. In addition of the primary structure, the effect of pre-strain, plastic strain, training cycle and training temperature on the TWSME was investigated. The prepared samples were trained in martensiti...
متن کاملIsothermal and Athermal Transformation of FeNiMo Alloys
Kinetic dependence of martensitic transformation and properties changes in Fe-24%Ni5%Mo alloys with different carbon content have been obtained. Internal friction method was used for the precise investigation of structural changes after austenization, during martensitic transformation at sub zero temperature and during the postheat. The influence: (i) of frequency of oscillations, (ii) rate of ...
متن کامل