The hot summer of 2010: redrawing the temperature record map of Europe.

نویسندگان

  • David Barriopedro
  • Erich M Fischer
  • Jürg Luterbacher
  • Ricardo M Trigo
  • Ricardo García-Herrera
چکیده

The summer of 2010 was exceptionally warm in eastern Europe and large parts of Russia. We provide evidence that the anomalous 2010 warmth that caused adverse impacts exceeded the amplitude and spatial extent of the previous hottest summer of 2003. "Mega-heatwaves" such as the 2003 and 2010 events likely broke the 500-year-long seasonal temperature records over approximately 50% of Europe. According to regional multi-model experiments, the probability of a summer experiencing mega-heatwaves will increase by a factor of 5 to 10 within the next 40 years. However, the magnitude of the 2010 event was so extreme that despite this increase, the likelihood of an analog over the same region remains fairly low until the second half of the 21st century.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The first record of Pomphorhynchus laevis (Acanthocephala) in Chub, Squalius cephalus (Linnaeus, 1758) (Pisces: Teleostei) from Gamasiab River, Hamedan, Iran

Pomphorhynchus laevis is a common fish parasite in Europe which   has been reported from Acipenser stellatus, Barbus capito, Barbus lacerta, Barbus mursa and Onchorhynchus mykiss in Iran. In a survey on the aquaculture potential of Gamasiab River in Hamedan Province, endemic fish parasites were investigated in summer and autumn 2008. After recording biometric characteristics, common necropsy an...

متن کامل

Optimization of Hot Workability in Ti-IF Steel by Using the Processing Map

Processing map for hot working of Ti-IF steel has been developed in the temperature range of 750 to 1100 °C and strain rate of 0.01 to 100 s-1. This map in the austenite region exhibits a single domain with a peak efficiency of 45% occurring at 1025 °C and strain rate of 0.02 s-1. The domain extends over the temperature range of 1000 to 1100 °C and strain rate range of 0.01 to 1 s-1. The true s...

متن کامل

Grain Size Effect on the Hot Deformation Processing Map of AISI 304 Austenitic Stainless Steel

In this study, the hot deformation processing map of AISI 304 austenitic stainless steel in two initial grain sizes of 15 and 40 μm was investigated. For this purpose, cylindrical samples were used in the hot compression test at the temperature range of 950-1100 °C and the strain rate of 0.005-0.5% s-1. At first, the relationship between the peak stress and Zener-Hollomon parameter w...

متن کامل

EVALUATING HOT DEFORMATION BEHAVIOR OF W360 TOOL STEEL BY HOT COMPRESSION TEST

In this research, the hot deformation behavior of W360 tool steel was investigated using hot compression test at 1000-1200°C and strain rates of 0.001, 0.01, 0.1, and 1 s-1. According to the results, dynamic recrystallization was found the most important restoration factor of this alloy during hot deformation. Recrystallization was enhanced with an increase in temperature and strain rate. Also,...

متن کامل

گنبد دوپوسته از منظر عملکرد حرارتی در اقلیم کویری کاشان

Since a large part of Iran is located in hot-dry climate, also the maximum amount of radiation absorbed is done from the roof in low-lying buildings among other facades in summer. And also the maximum area of the outer shell of the building is dedicated to the ceiling. Further, the most energy consumption is devoted to the building, and there is high cost of cooling  in the summer in Iran. Henc...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Science

دوره 332 6026  شماره 

صفحات  -

تاریخ انتشار 2011