Effect of tool surface topography on friction with carbon fibre tows for composite fabric forming
نویسندگان
چکیده
http://dx.doi.org/10.1016/j.compositesa.2016.10.017 1359-835X/ 2016 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/). ⇑ Corresponding author presently at: School of Engineering, University of Glasgow, G12 8QQ, UK. E-mail address: [email protected] (D.M. Mulvihill). Daniel M. Mulvihill ⇑, Michael P.F. Sutcliffe
منابع مشابه
Friction of carbon fibre tows
The fundamental frictional behaviour of carbon fibre tows relevant to composite fabric forming is explored. Tow-on-tool and tow-on-tow contact are considered. For tow-on-tool contact, an experiment is devised to simultaneously observe the true filament contact length and measure the friction force over a range of normal loads. Filament contact length is not constant, as would be given from an i...
متن کاملFriction in Textile Thermoplastic Composites Forming
A previously developed mesoscopic friction model for glass/PP textile composite laminates during forming is evaluated for glass and carbon/PPS laminates, at higher temperatures and lower viscosities than before. Experiments were performed for tool/ply and ply/ply configurations in a new friction test set-up. The experimental results indicate that this contact is indeed in the hydrodynamic regim...
متن کاملInvestigating the effect of tool dimension and rotational speed on microstructure of Al-B4C surface composite layer produced by friction stir processing (FSP)
Friction stir processing (FSP) was used for the fabrication of Al-B4C surface composite. Al-Mg-Si alloy was considered as the substrate and B4C particles were incorporated into the substrate by thermo-mechanical effect of FSP. The effect of tool dimensions and different rotational speeds on the microstructure and microhardness of the composite layers was evaluated and the optimum process parame...
متن کاملEffect of surface treatments on damping behavior of carbon and glass fiber reinforced friction material
The ability to absorb vibrations in a vehicle during braking conditions depends primarily on the selection of ingredients for a friction material and interfacial adhesion between all these ingredients. In this work, a hybrid brake friction material is developed by combination of carbon fiber (CF), glass fiber (GF), resin and other ingredients. The surfaces of carbon and glass fibers are c...
متن کاملCompressive response of a 3D non-woven carbon-fibre composite
The compressive response of a three-dimensional (3D) non-interlaced composite comprising three orthogonal sets of carbon fibre tows within an epoxy matrix is analysed. First, the compressive response is measured in three orthogonal directions and the deformation/failure modes analysed by a combination of X-ray tomography and optical microscopy. In contrast to traditional unidirectional and two-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2017