An analysis of injury claims from low-seam coal mines.
نویسندگان
چکیده
INTRODUCTION The restricted workspace present in low-seam coal mines forces workers to adopt awkward working postures (kneeling and stooping), which place high physical demands on the knee and lower back. METHOD This article provides an analysis of injury claims for eight mining companies operating low-seam coal mines during calendar years 1996-2008. All cost data were normalized using data on the cost of medical care (MPI) as provided by the U.S. Bureau of Labor Statistics. RESULTS Results of the analysis indicate that the knee was the body part that led in terms of claim cost ($4.2 million), followed by injuries to the lower back ($2.7 million). While the average cost per injury for these body parts was $13,100 and $14,400, respectively (close to the average cost of an injury overall), the high frequency of these injuries resulted in their preeminence in terms of cost. Analysis of data from individual mining companies suggest that knee and lower back injuries were a consistent problem across companies, as these injuries were each among the top five most costly part of body for seven out of eight companies studied. APPLICATION/IMPACT: Results of this investigation suggest that efforts to reduce the frequency of knee and low back injuries in low-seam mines have the potential to create substantial cost savings.
منابع مشابه
Application of an integrated decision-making approach based on FDAHP and PROMETHEE for selection of optimal coal seam for mechanization; A case study of the Tazareh coal mine complex, Iran
Increasing the production rate and minimizing the related costs, while optimizing the safety measures, are nowadays’ most important tasks in the mining industry. To these ends, mechanization of mines could be applied, which can result in significant cost reductions and higher levels of profitability for underground mines. The potential of a coal mine mechanization depends on some important fact...
متن کاملStudying Relationship between Coal Intrinsic Characteristics in Spontaneous Combustion of Coal Potential Using Crossing Point Temperature Test Method
Spontaneous combustion of coal is one of the most horrifying hazards in coal industries, especially in underground coal mines. Thus having a prior knowledge about the occurrence of this phenomenon in underground coal mines is of crucial importance in preventing this process, loss of life, huge economic loss, and environmental pollution. The aim of this work is to determine the spontaneous combu...
متن کاملElestoplastic Analysis of Barrier Pillars Above the Drifts in Inclined Seam (TECHNICAL NOTES)
In this paper, the effects of horizontal stress and dimensions of barrier pillars on the stability of drifts hr been investigated. An elastoplastic hybrid finite/boundary element program has been used. A plastic analysis of stresses in barrier pillars above the drifts in one of the underground coal mines with inclined seams is examined. Computed stresses and safety factor controur lines around ...
متن کاملEffect of air column in transport canisters on measured gas contents of coal
Canister desorption is a widely used technique to measure the gas content of coal. The gas content data, when normalized to volume/weight and multiplied by coal seam mass, is used to estimate the gas in place in an area around the cored hole. However, the gas content and the percentage of each constituent are likely to be influenced by trapped air in the canister at the time of the coal enclosu...
متن کاملPreventing Falls of Ground in Coal Mines with Exceptionally Low-Strength Roof: Two Case Studies
Mines with exceptionally low-strength roof (UCS <3,500 psi and CMRR <40) are much more likely to struggle with roof falls than other mines. Weak roof is a particular problem for many room and pillar mines in the Midwestern and Northern Appalachian coal basins. Traditional roof support techniques are often not up to the challenge at these operations. This paper focuses on two mines, one operatin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Journal of safety research
دوره 40 3 شماره
صفحات -
تاریخ انتشار 2009