Hysteresis-free reactive high power impulse magnetron sputtering
نویسنده
چکیده
High power impulse magnetron sputtering (HIPIMS) of an Al target in Ar/O2 mixtures has been studied. The use of HIPIMS is shown to drastically influence the process characteristics compared to conventional sputtering. Under suitable conditions, oxide formation on the target as the reactive gas flow is increased is suppressed, and the hysteresis effect commonly observed as the gas flow is varied during conventional sputtering can be reduced, or even completely eliminated, using HIPIMS. Consequently, stoichiometric alumina can be deposited under stable process conditions at high rates. Possible explanations for this behavior as well as a model qualitatively describing the process are presented.
منابع مشابه
Time and energy resolved ion mass spectroscopy studies of the ion flux during high power pulsed magnetron sputtering of Cr in Ar and Ar/N2 atmospheres
Mass spectroscopy was used to analyze the energy and composition of the ion flux during high power pulsed magnetron sputtering (HIPIMS/HPPMS) of a Cr target in an industrial deposition system. The ion energy distribution functions were recorded in the time-averaged and time-resolved mode for Ar + , Ar 2+ , Cr + , Cr 2+ , N2 + and N + ions. In the metallic mode the dependence on pulse energy (eq...
متن کاملProcess stabilization by peak current regulation in reactive high-power impulse magnetron sputtering of hafnium nitride
A simple and cost effective approach to stabilize the sputtering process in the transition zone during reactive high-power impulse magnetron sputtering (HiPIMS) is proposed. The method is based on real-time monitoring and control of the discharge current waveforms. To stabilize the process conditions at a given set point, a feedback control system was implemented that automatically regulates th...
متن کاملEnergy flux measurements in high power impulse magnetron sputtering
The total energy flux in a high power impulse magnetron sputtering (HiPIMS) plasma has been measured using thermal probes. Radial flux (parallel to the magnetron surface) as well as axial flux (perpendicular to the magnetron surface) were measured at different positions, and resulting energy flux profiles for the region between the magnetron and the substrate are presented. It was found that th...
متن کاملCrNx Films Prepared by DC Magnetron Sputtering and High-Power Pulsed Magnetron Sputtering: A Comparative Study
CrNx (0 ≤ x ≤ 0.91) films synthesized using highpower pulsed magnetron sputtering, also known as high-power impulse magnetron sputtering (HiPIMS), have been compared with those made by conventional direct-current (dc) magnetron sputtering (DCMS) operated at the same average power. The HiPIMS deposition rate relative to the DCMS rate was found to decrease linearly with increasing emission streng...
متن کاملExploring the potential of high power impulse magnetron sputtering for growth of diamond-like carbon films
Amorphous carbon films are deposited employing high power impulse magnetron sputtering (HiPIMS) at pulsing frequencies of 250 Hz and 1 kHz. Films are also deposited by direct current magnetron sputtering (dcMS), for reference. In both HiPIMS and dcMS cases, unipolar pulsed negative bias voltages up to 150 V are applied to the substrate to tune the energy of the positively charged ions that bomb...
متن کامل