Genesis of Brønsted Acid Sites during Dehydration of 2-Butanol on Tungsten Oxide Catalysts

نویسندگان

  • Chelsey D. Baertsch
  • Kenny T. Komala
  • Yong-Hwee Chua
  • Enrique Iglesia
چکیده

In situ measurements of Brønsted acid sites (by titration with 2,6-di-tert-butyl-pyridine) and reduced centers (by UV–vis spectroscopy) were carried out on WOx–ZrO2 with catalysts at 2.9– 32.3 W/nm2 in order to probe how these species form and act as active sites during 2-butanol dehydration. The rate of 2-butanol dehydration (per W-atom) on WOx–ZrO2 reached maximum values at intermediate WOx surface densities, as was also found previously for o-xylene and n-pentane isomerization. Polytungstate domains prevalent at these surface densities balance the accessibility of W6+ centers with their ability to reduce to form Brønsted acid sites via reduction with 2-butanol. In situ UV–vis spectra showed that 2-butanol reduces WOx species and that the highest density of the Brønsted acid sites formed is obtained at WOx surface densities similar to those required for maximum dehydration rates. Brønsted acid site densities were measured during 2-butanol reaction using sterically hindered 2,6-di-tert-butyl-pyridine, which titrates only Brønsted acid sites. 2-Butanol dehydration requires Brønsted acid sites that form during reaction at low concentrations (0.040 sites/W-atom) and reach their highest concentration at intermediate WOx surface densities (6.8–14.8 W/nm2). Pre-edge features in UV–vis spectra are weak for monotungstate species (<4 W/nm2) and their intensity increase is parallel to that observed in 2-butanol dehydration rates, confirming the requirement for active Hδ+ (WO3)δ− n species, formed during reaction and stabilized by polytungstate domains. Turnover rates (per Brønsted acid site) are much higher on WOx–ZrO2 than on Lewis acid sites active for 2butanol dehydration on γ -Al2O3. 2-Butanol dehydration turnover rates (per Brønsted acid site) on SiO2-supported tungstophosphoric acid (HPW), however, are higher than those on WOx–ZrO2. The mechanism-based rate equation developed for 2-butanol dehydration and the faster secondary butene isomerization found on HPW suggest that acid sites are weaker on HPW than on WOx–ZrO2. A weaker acidity is indeed expected from the stronger conjugate base provided by the smaller WOx domains and the larger H+/W ratio in HPW clusters. Weaker acid sites allow faster product desorption and higher turnover rates from saturated surfaces during 2-butanol dehydration. c © 2002 Elsevier Science

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Solid acid catalysts based on supported tungsten oxides

Supported WOx clusters are active and stable catalysts for isomerization, dehydration, and cracking reactions. Brønsted acid sites form on WOx clusters when a lower valent element replaces W6+ or when W6+ centers reduce slightly during catalytic reactions. WOx clusters of intermediate size provide the balance between reducibility and accessibility required to maximize the number of surface H+ s...

متن کامل

Nature of WOx Sites on SiO2 and Their Molecular Structure− Reactivity/Selectivity Relationships for Propylene Metathesis

Supported WOx/SiO2 catalysts were investigated for propylene metathesis as a function of tungsten oxide loading and temperature. The catalysts were synthesized by incipient-wetness impregnation of an aqueous ammonium metatungstate solution onto the silica support and calcined at elevated temperatures to form the supported tungsten oxide phase. In situ Raman spectroscopy under dehydrated conditi...

متن کامل

Synthesis, characterization, and catalytic function of novel highly dispersed tungsten oxide catalysts on mesoporous silica

The physical and chemical properties of tungsten oxide supported on SBA-15 mesoporous silica prepared by a controlled grafting process through atomic layer deposition (ALD) were studied using complementary characterization methods. X-ray diffraction, optical absorption, and transmission electron microscopy showed that tungsten oxide species are highly dispersed on SBA-15 surfaces, even at 30 wt...

متن کامل

Butanol Dehydration over V2O5-TiO2/MCM-41 Catalysts Prepared via Liquid Phase Atomic Layer Deposition

MCM-41 was used as a support and, by using atomic layer deposition (ALD) in the liquid phase, a catalyst was prepared by consecutively loading titanium oxide and vanadium oxide to the support. This research analyzes the effect of the loading amount of vanadium oxide on the acidic characteristics and catalytic performance in the dehydration of butanol. The physical and chemical characteristics o...

متن کامل

Defective Tungsten Oxide Hydrate Nanosheets for Boosting Aerobic Coupling of Amines: Synergistic Catalysis by Oxygen Vacancies and Brønsted Acid Sites.

Adsorption and activation of molecules on a surface holds the key to heterogeneous catalysis toward aerobic oxidative reactions. To achieve high catalytic activities, a catalyst surface should be rationally tailored to interact with both organic substrates and oxygen molecules. Here, a facile bottom-up approach to defective tungsten oxide hydrate (WO3 ·H2 O) nanosheets that contain both surface...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001