Melt Flow Characterization in Continuous Casting Tundishes
نویسنده
چکیده
Melt flow in continuous casting tundishes is normal[y characterized by a combined model. The model is used to analyze the residence time disttibution of fluid in a tundish, In this model, the fluid volume in tundish is considered to be consisting of the plug flow, well-mixed flow, and dead volumes. Although this model was proposed over 20 years ago, most researchers have either used it incorrectly or madean assumption in analyzing melt flow in tundishes. Both approaches may lead to incorrect and misleading calculations of the dead volume. In this paper, the combined model has been discussed and its correct application to tundish melt flow has been outlined,
منابع مشابه
Tundish Nozzle Clogging – Application of Computational Models
Clogging of the tundish nozzle is a major castability problem in continuous casting of steel for several reasons. Firstly, clogging increases the frequency of operation disruptions to change nozzles or tundishes or even to stop casting. These extra transitions increase operating cost, decrease productivity, and lower quality. Secondly, clogging can lead directly to a variety of quality problems...
متن کاملClogging in Continuous Casting Nozzles
Nozzle clogging is a serious productivity and quality problem in continuous casting. This work reviews the causes, effects, and solutions to clogging in continuous casting nozzles. The results of a one-dimensional, steady state analysis of the heat loss from the molten steel stream through the nozzle wall are discussed. The analyses show that steel may freeze within the clog matrix for a relati...
متن کاملMathematical Simulation for the Effects of Flow Control Devices in a Six- strand Tundish in Continuous Casting of Steel Billet
The method of continuous casting of steel is now often used in the metallurgical industry, due to the increasing demand for the production of high – quality steel. An important device of continuous casting machine is the tundish, in which a stabilized steel flow has a crucial effect on the quality and efficiency conditions of the continuous casting process. In this study fluid flows in a six – ...
متن کاملSimulation of the Continuous Casting and Cooling Behavior of Metallic Glasses
The development of melt spinning technique for preparation of metallic glasses was summarized. The limitations as well as restrictions of the melt spinning embodiments were also analyzed. As an improvement and variation of the melt spinning method, the vertical-type twin-roll casting (VTRC) process was discussed. As the thermal history experienced by the casting metals to a great extent determi...
متن کاملPhysical Modeling of Steel Delivery during Thin Slab Continuous Casting
A full scale physical model of a thin slab caster with a four-hole design submerged entry nozzle (SEN) was constructed. On the basis of the dimensionless Reynolds and Froude similitude criteria, the fluid flow in a full-scale model is similar to that of the actual system and, hence, the data obtained from the water model can be applied to the actual system. In order to determine the optimum ope...
متن کامل