Effect of Iron Additives on the Microstructure of Hydroxyapatite
نویسنده
چکیده
In this article, some Fe (III) doped hydroxyapatite samples (FeHAp) were prepared using the wet chemical method. The prepared samples were characterized via the use of X-ray diffraction (XRD) and scanning electron microscopy (SEM). Detailed structural analysis were done by Scherrer and Williamson–Hall plot methods to detect the effect of iron on the structure of hydroxyapatite (HAp). XRD patterns showed that all samples were single phased HAp. Relations between the Fe content and the deformation of the lattice parameters, dislocation density, grain size, microstrain, crystallinity were investigated. The presence of iron in the HAp lattice is found to decrease both the crystal size and the dislocation density. Further results are presented and discussed. KeywordsHydroxyapatite; Lattice parameters; Dislocation density; Crystallite size; Microstrain
منابع مشابه
Effects of MWCNTs Dispersion on the Microstructure of Sol-Gel Derived Hydroxyapatite
Stable homogeneous dispersions of carbon nanotubes (CNTs) were prepared using ethanol as dispersing agent. Then, using sol-gel method, dispersion in the hydroxyapatite matrix and its effects on the microstructure were investigated. The phase composition, chemical structure and morphological and size analyses were performed using XRD, FT-IR, SEM, TEM/SAED/EDX and Raman spectroscopy. The influenc...
متن کاملEffect of Alloying Elements on the Microstructure and Mechanical Properties of Austempered Ductile Iron Alloys
متن کامل
Effect of Alloying Elements on the Microstructure and Mechanical Properties of Austempered Ductile Iron Alloys
متن کامل
The Effect of Heat Treatment Cycle on Microstructure and Mechanical Properties of Austempered Ductile Iron with Various Copper Contents.
متن کامل
EFFECT OF GRAPHITE FLAKES ON THE MICROSTRUCTURE OF MELTED, TRANSITION AND HEAT AFFECTED ZONES IN GREY CAST IRON REMELTED BY TIG
Abstract:transition and heat affected zones formed during surface remelting (in order to improve wear resistance) with TIGprocess has been investigated. Relationship between various TIG parameters and thickness of remelted and heataffected zones revealed that a high concentrated heat energy is imposed by TIG process which makes it a proper optionfor focused surface treatment. Based on microstru...
متن کامل