Rail-To-Rail Output Op-Amp Design with Negative Miller Capacitance Compensation
نویسنده
چکیده
Abstract—In this paper, a two-stage op-amp design is considered using both Miller and negative Miller compensation techniques. The first op-amp design uses Miller compensation around the second amplification stage, whilst the second op-amp design uses negative Miller compensation around the first stage and Miller compensation around the second amplification stage. The aims of this work were to compare the gain and phase margins obtained using the different compensation techniques and identify the ability to choose either compensation technique based on a particular set of design requirements. The two op-amp designs created are based on the same two-stage rail-to-rail output CMOS op-amp architecture where the first stage of the op-amp consists of differential input and cascode circuits, and the second stage is a class AB amplifier. The op-amps have been designed using a 0.35m CMOS fabrication process.
منابع مشابه
Designing 1-V Op Amps Using Standard Digital CMOS Technology
This paper addresses the difficulty of designing 1-V capable analog circuits in standard digital complementary metal–oxide–semiconductor (CMOS) technology. Design techniques for facilitating 1-V operation are discussed and 1-V analog building block circuits are presented. Most of these circuits use the bulk-driving technique to circumvent the metal– oxide–semiconductor field-effect transistor t...
متن کاملA Digitally Programmable Rail-to-Rail CMOS Operational Amplifier as Reusable Silicon IP
A digitally programmable rail-to-rail CMOS operational amplifier (Op Amp) is designed using standard 0.35 um CMOS process. By using an efficient MOS capacitor is used to compensate the stability of the Op Amp. A compensation current switch is used to adjust the slew rate. Using the schemes, the Op Amp can obtain improved the stability, bandwidth, slew rate and settling time according to the out...
متن کاملA Low-voltage CMOS Op Amp with a Rail-to-rail Constant-gm Input Stage and a Class AB Rail-to-rail Output Stage
Absfrucf In this paper a low-voltage two-stage O p Amp is presented. The O p Amp features rail-to-rail operation and has an @put stage with a constant transconductance (%) over the entire common-mode input range. The input stage consists of an nand a PMOS differential pair connected in parallel. The constant gm is accomplished by regulating the tail-currents with the aid of an MOS translinear (...
متن کامل1-V quasi constant-gm input/output rail-to-rail CMOS op-amp
A CMOS operational amplifier with input/output rail-to-rail range is presented. The circuit operates with a 1-V single supply. It uses dynamically biased input level shifters, controlled by a novel tuning scheme, to extend the input common-mode voltage range from one rail to the other. The tuning circuit takes the total biasing current of the amplifier input stage and, hence, its small-signal r...
متن کاملCMOS Technology and Current-feedback Op-Amps
The implementation of currentfeedback op-amps (CFB op-amps) relies on the use of a semiconductor process with complementary device structures for class AB operation of the input and output stages. Thus, CMOS technology is an obvious candidate. However, commercial CFB opamps are all realized in bipolar processes. In this paper we identify some of the problems related to the application of CMOS t...
متن کامل