Modeling with current dynamics and vibration control of two phase hybrid stepping motor in intermittent drive
نویسندگان
چکیده
This paper presents modeling of stepping motor and control design of input pulse timing for the suppression control of vibration. The stepping motor has the transient response of electric current for the pulse input. Therefore, the motor model considering the transient response of the current is built. The validity of the proposed model is verified by comparing the model considering the transient response of the current with the one without its consideration. Design of the pulse input timing in the method of the four pulse drive is realized to achieve the desired angle without vibration and overshoot using an optimization method. Finally, the effectiveness of the proposed method is demonstrated by comparing simulation results with experiments.
منابع مشابه
A New Hybrid Brushless DC Motor/Generator without Permanent Magnet
The Brushless DC (BLDC) motor is a simple robust machine which has found application over a wide power and speed of ranges in different shapes and geometry. This paper briefly reviews the fundamentals behind the motor and also the different types of BLDC motors with different geometries and then presents a new configuration for BLDC motor/generator, which does not use a permanent magnet in the ...
متن کاملA Low Cost Sensorless Control Drive Circuit for of Low Voltage Switched Reluctance Motor
Shaft position sensing is an essential part of switched reluctance (SR) motor drive In order to synchronize the pulses of phase current with the period of rising inductance of the proper motor phase. Direct sensors such as, Hall effect and optical encoder are commonly used in SR motors. The purpose of this paper is to present an indirect shaft positioning sensing known as "sensorless " control ...
متن کاملSpace Vector Pulse Width Modulation with Reduced Common Mode Voltage and Current Losses for Six-Phase Induction Motor Drive with Three-Level Inverter
Common-mode voltage (CMV) generated by the inverter causes motor bearing failures in multiphase drives.On the other hand, presence of undesired z-component currents in six-phase induction machine (SPIM) leads to extra current losses and have to be considered in pulse width modulation (PWM) techniques. In this paper, it is shown that the presence of z-component currents and CMV in six phase driv...
متن کاملImplementation of a Novel Brushless DC Motor Drive based on One-Cycle Control Strategy
In this paper, one-cycle control (OCC), as a constant-frequency PWM control strategy for current control of a six-switch brushless dc (BLDC) motor drive is investigated. Developed current regulator is a unified controller and PWM modulator. Employing the one-cycle control strategy, decreases the torque ripple resulted from the conventional hysteresis current controllers and therefore, the vibra...
متن کاملThe Influence of DC-Link Voltage on Commutation Torque Ripple of Brushless DC Motors with Two-Segment Pulse-width Modulation Control Method
The commutation process causes current ripple to be generated in the drive system of brushless DC (BLDC) motor. This, in turn, leads to output torque ripple. Mechanical vibration and acoustic noise are its influences which are undesirable phenomenon in some applications. A new method is presented in this paper which reduces torque ripple and commutation period in the entire range of motor speed...
متن کامل