CFD Modeling of PROX Microreactor for Fuel Processing
نویسندگان
چکیده
In order to investigate a PROX microreactor performance, two-dimensional modeling of the reacting flow between two parallel plates is performed through a finite volume method using an improved SIMPLE algorithm. A three-step surface kinetics including hydrogen oxidation, carbon monoxide oxidation and water-gas shift reaction is applied for a Pt-Fe/γ-Al2O3 catalyst and operating temperatures of about 100oC. Flow pattern, pressure field, temperature distribution, and mole fractions of species are found in the whole domain for all cases. Also, the required reactive length for removing carbon monoxide from about 2% to less than 10 ppm is found. Furthermore, effects of hydraulic diameter, wall temperature, and inlet mole fraction of air and water are investigated by considering carbon monoxide selectivity and conversion. It is found that air and water addition may improve the performance of the microreactor in carbon monoxide removal in such operating conditions; this is in agreement with the pervious published results. Keywords—CFD, Fuel Processing, PROX, Reacting Flow, SIMPLE algorithm.
منابع مشابه
A CFD Simulation of Hydrogen Production in Microreactors
In this study, the modeling of hydrogen production process in microreactors by methanol-steam reforming reaction is investigated. The catalytic reaction of methanol-steam reforming producing hydrogen is simulated considering a 3D geometry for the microreactor. To calculate diffusion among species, mixture average correlations are compared to Stephan-Maxwell equations. The reactions occurring in...
متن کاملPreferential Oxidation of Carbon Monoxide in a Thin-film Catalytic Microreactor: Advantages and Limitations
Silicon microreactors with thin-film wall catalyst were adopted for kinetic studies of CO preferential oxidation (PrOx). The activity of this catalyst was compared to other catalyst systems based on similar formulation. Internal and external mass transport and heat transport limitations of the microreactor were examined and comparisons were made to typical packed-bed lab reactors (m-PBR's). We ...
متن کاملEffect of platinum on Ceria supported Cu catalysts for PrOx process in fuel processors
The CO preferential oxidation (PrOx) is one of the critical steps in hydrogen production and purification for Polymer Electrolyte Membrane Fuel Cell (PEMFC). This reaction was investigated in the presence of excess hydrogen over Cu/CeO2, Pt/CeO2 and Cu-Pt/CeO2 catalysts. The ceria supports was prepared via precipitation method and Cu-Pt/CeO2 catalyst was synthesized by sequential impregnation o...
متن کاملOptimization of Preparation Factors for Cerium Oxide Synthesis as a Support for CO PrOx Catalyst
Nanocrystalline ceria has been considered as support for carbon monoxide preferentially oxidation. In this study ceria was prepared by precipitation method and the effects of preparation conditions, such as pH of solution (8-10), aging time (1-12 hr), drying temperature (80-120 °C), calcination time (2-6 hr) and temperature (400-600 °C) were investigated on ceria synthesized powders properties....
متن کاملCfd Methodology and Validation for Single-phase Flow in Pwr Fuel Assemblies
This paper presents the CFD modeling methodology and validation for steady-state, normal operation in a PWR fuel assembly. This work is part of a program that is developing a CFD methodology for modeling and predicting single-phase and two-phase flow conditions downstream of structural grids that have mixing devices. The purpose of the mixing devices (mixing vanes in this case) is to increase t...
متن کامل