A Convection/Radiation Temperature Control System for High Power Density Electronic Device Testing
نویسندگان
چکیده
Active control of die-level temperature is required during production testing of high power microprocessors in order to ensure accurate performance classification, but control is becoming more difficult as the device power densities increase. With power densities approaching 100 W /cm2, the current passive control systems are no longer able to maintain the required temperature tolerance for production testing. This paper describes the design and testing of a temperature control system that combines high performance impingement cooling with higher power laser heating with application to packaged integrated circuit devices under dynamic testing conditions. Also presented are system design concepts and experimental results for typical microprocessor thermal test vehicles. DOI: 10.1115/1.2966437
منابع مشابه
Optimal Intelligent Control of Plug-in Fuel Cell Electric Vehicles in Smart Electric Grids
In this paper, Plug-in Fuel Cell Electric Vehicle (PFCEV) is considered with dual power sources including Fuel Cell (FC) and battery Energy Storage. In order to respond to a transient power demand, usually supercapacitor energy storage device is combined with fuel cell to create a hybrid system with high energy density of fuel cell and the high power density of battery. In order to simulate the...
متن کاملDevice-layer Ovenization of Fused Silica Micromechanical Resonators for Temperature-stable Operation
In this paper, we report on temperature-stable operation of multiple MEMS silica resonators on an ovenized fused silica device-layer. Temperature servo-control circuits are implemented for compensating the resonator frequency drift using an on-chip RTD-based temperature sensor. A wide linear range analog controller has been implemented to reduce the effective TCF of fused silica resonator by an...
متن کاملEffect of slip and variable thermal boundary conditions on hydromagnetic mixed convection flow and heat transfer from a non-linearly stretching surface
The effect of partial slip and temperature dependent fluid properties on the MHD mixed convection flow from a heated, non-linearly stretching surface in the presence of radiation and non-uniform internal heat generation/absorption is investigated. The velocity of the stretching surface was assumed to vary according to power-law form. Thermal transport is analyzed for two types of non-isothermal...
متن کاملDesign and Fabrication of a Microwave Weed Killer Device for Weed Control Applications
In this paper, the design and the results of a microwave radiation system for agriculture applications is discussed. The system is fabricated and successfully tested on weed seeds. The device, which uses a commercial 1 kW magentron, proved to be effective for preventing the germination control of popular weeds of Iran. Seven weed species were tested separately by using this system and then the ...
متن کاملFlexible Power Electronic Transformer for Power Flow Control Applications
This paper proposes a Flexible Power Electronic Transformer (FPET) for the application in the micro-grids. The low frequency transformer is usually used at the Point of Common Coupling (PCC) to connect the low voltage grid and utility network to each other. The conventional 50Hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. In this pap...
متن کامل