Design of plastics injection molds for short-run production: a rapid prototyping approach

Signoret, Christian Victor, "Design of plastics injection molds for short-run production: a rapid prototyping approach " (1998). This manuscript has been reproduced from the microfilm master. UMI films the text directly from the original or copy submitted. Thus, some thesis and dissertation copies are in typewriter face, while others may be from any type of computer printer. The quality of this reproduction is dependent upon the quality of the copy submitted. Broken or indistinct print, colored or poor quality illustrations and photographs, print bleedthrough, substandard margins, and improper alignment can adversely affect reproduction. In the unlikely event that the author did not send UMI a complete manuscript and there are missing pages, tiiese will be noted. Also, if unauthorized copyright material had to be removed, a note will indicate the deletion. sectioning the original, beginning at the upper left-hand comer and continuing from left to right in equal sections with small overiaps. Photographs included in tiie original manuscript have been reproduced xerographically In this copy. Higher quality 6" x 9" black and white photographic prints are available for any photographs or illustiBti'ons appearing in tiiis copy for an additional charge. Contact UMI directiy to order.