Assessment of the Vibration on the Foam Legged and Sheet Metal-legged Passenger Seat
نویسنده
چکیده
L. Dahil, Istanbul Aydın University, Department of Mechanical and Metal Technologies, Turkey. A. Karabulut, Afyon Kocatepe University, Faculty of Technology, Mechanical Engineering, Turkey. In this study, it was aim ed to decrease the vibration reaching to passenger from the legs of vehicle seats. In order to determine the levels of vibrations reaching at passengers, a test pad placed under the passenger seat was used, and HVM100 device was used for digitizing the information obtained. By transferring the vibration data to system by using HVM100 device, the acceleration graphics were prepared with Blaze software. As a result, it was determined that the acceleration values of seat legs made of foam material were lower than that of seat legs made of 2 mm thick sheet metal, so they damped the vibration better.
منابع مشابه
Vibration characteristics of tractor seat cushion materials
Operators of agricultural machinery are exposed to an extensive range of indirect vibrations through the seats, which gradually causes chronic damages. One of the ways to reduce the vibrations imposed on the operators is to use appropriate materials in tractor seat cushion. The present study was carried out in order to select appropriate foam or sponge and investigate different factors in reduc...
متن کاملConceptual Design of an Integrated Bus Passenger Seat
Travel by bus with long hours will create discomfort feeling for bus passenger. Long hour travel will create physiological stress and psychological stress on bus passenger. It may due to vibration, noise, as well as seat comfort. Seat comfort is a subjective feeling of bus passenger. In this research, air cushion was used to replace the part of the seat foam. During the development of the integ...
متن کاملSeismic Response of 4-Legged Self-Supporting Telecommunication Towers
Telecommunication tower is an important component of the basic infrastructure of communication systems and thus preserving them in events of natural disasters - such as a severe earthquake - is of high priority. In past studies, researchers have mostly considered the effects of wind and earthquake-induced loads on 3-legged (triangular cross-section) self-supporting steel telecommunication tower...
متن کاملThe Effect of Six-Legged Concrete Elements on Hydraulic Jump Characteristics
In the present study, the six legged concrete (SLC) elements are placed at the bed of a flume downstream of a chute in different layouts, densities and number of longitudinal rows of SLC elements. Each test was run for different flow conditions (Froude numbers ranged 5.3 to 8.1). During each test, the water surface profile, the roller length and the jump length measured. Applying the experimen...
متن کاملStiffness control of a legged robot equipped with a serial manipulator in stance phase
The ability to perform different tasks by a serial manipulator mounted on legged robots, increases the capabilities of the robot. The position/force control problem of such a robot in the stance phase with point contacts on the ground is investigated here. A target plane with known stiffness is specified in the workspace. Active joints of the legs and serial manipulator are used to exert the de...
متن کامل