Dynamic Identification of Manipulator: Comparison between CAD and Actual Parameters
نویسندگان
چکیده
It is essential to know the dynamic parameters of the robot for its precise control and simulation. Philosophy of identification is based on finding the model using its input-output data. The identification equation of the manipulator is derived from Newton-Euler equations, using manipulator kinematic, i.e., geometric parameters and joint values as input and joint torque data as output. In this paper, the dynamic parameters are identified for the CAD model provided by the robot manufacturer in simulation. And experimentally for the installed seven degrees of freedom (DOF) robot KUKA-iiwaR800. The variation between the joint torques predicted from the estimated base parameters obtained using CAD model and actual robot are presented. The factors responsible for the variation are also highlighted.
منابع مشابه
Dynamic Parameter Identification of Parallel Robots Considering Physical Feasibility and Nonlinear Friction Models
This paper deals with the identification problem of the inertial and frictional parameters of a parallel manipulator. Two important issue are considered; the physical feasibility of the identified inertial parameters and the use of linear and nonlinear friction models. The dynamic model, analyzed and reduced to a set of base parameters through the Singular Value Decomposition, is derived starti...
متن کاملKinematic and Dynamic Analysis of Tripteron, an Over-constrained 3-DOF Translational Parallel Manipulator, Through Newton-Euler Approach
In this research, as the main contribution, a comprehensive study is carried out on the mathematical modeling and analysis of the inverse kinematics and dynamics of an over-constraint three translational degree-of-freedom parallel manipulator. Due to the inconsistency between the number of equations and unknowns, the problem of obtaining the constraint forces and torques of an over-constraint m...
متن کاملAdaptive Control of a 3-DOF Parallel Manipulator Considering Payload Handling and Relevant Parameter Identification
A model-based control system may produce a substantial increase in the overall performance of parallel robots, thus allowing less expensive manufacturing. Although dynamic parameter identification is an experimental technique that significantly improves data feeding dynamic models, some difficulties arise: the effect of the parallel robot's unmodeled dynamics, the variation of some dynamic para...
متن کاملDistillation Column Identification Using Artificial Neural Network
 Abstract: In this paper, Artificial Neural Network (ANN) was used for modeling the nonlinear structure of a debutanizer column in a refinery gas process plant. The actual input-output data of the system were measured in order to be used for system identification based on root mean square error (RMSE) minimization approach. It was shown that the designed recurrent neural network is able to pr...
متن کاملDynamic Modeling of a Robot Manipulator for Opening the Tap Hole of an Electric Arc Furnace
The electric arc furnace (EAF) is used to produce high quality steel from steel scraps. The EAF uses plasma arc to generate heat for melting scarp or direct reduced iron (DRI). The liquid metal should be drained from the tap hole. Manual tapping operation of the EAF in the hot environment around the furnace is a potentially dangerous and time consuming task for the workers. Therefore, it is ess...
متن کامل