High-gain power recycling of a Fabry-Perot Michelson interferometer for a gravitational-wave antenna.
نویسندگان
چکیده
Power recycling was implemented on a fully suspended prototype interferometer with arm lengths of 20 m. A wave-front-sensing technique for alignment control of the suspended mirrors was also implemented, which allowed for several hours of stable operation. A power-recycling gain of greater than 12 was achieved, a significant increase over the highest gain in a suspended mirror Fabry-Perot Michelson interferometer reported to date.
منابع مشابه
Experimental test of an alignment-sensing scheme for a gravitational-wave interferometer.
An alignment-sensing scheme for all significant angular degrees of freedom of a power-recycled Michelson interferometer with Fabry-Perot cavities in the arms was tested on a tabletop interferometer. The response to misalignment of all degrees of freedom was measured at each sensor, and good agreement was found between measured and theoretical values.
متن کاملDemonstration of a power-recycled Michelson interferometer with Fabry-Perot arms by frontal modulation.
Large-scale gravitational-wave detectors currently under construction such as the LIGO detectors use multiplemirror resonant optical systems containing several surfaces at which the relative phase of interfering light beams must be controlled. We describe a tabletop experiment that demonstrates a scheme for extracting signals in such an interferometer corresponding to deviations from perfect in...
متن کاملAnalysis of light noise sources in a recycled Michelson interferometer with Fabry-Perot arms.
We present a method by which the effect of laser field variations on the signal output of an interferometric gravitational wave detector is rigorously determined. Using the Laser Interferometer Gravitational Wave Observatory (LIGO) optical configuration of a power recycled Michelson interferometer with Fabry-Perot arm cavities as an example, we calculate the excess noise after the input filter ...
متن کاملLinewidth-broadened Fabry–Perot cavities within future gravitational wave detectors
The bandwidth of LIGO-like terrestrial interferometric gravitational wave detectors is set by the pole of the Fabry–Perot cavities within the arms of the Michelson interferometer. This constraint arises because the gain of gravitational wave-induced signal sidebands is limited to frequencies within the linewidth of the cavities. The nature of standard Fabry–Perot cavities is such that one canno...
متن کاملDiffractively coupled Fabry-Perot resonator with power-recycling.
We demonstrate the optical coupling of two cavities without light transmission through a substrate. As the all-reflective coupling component, we use a dielectric low-efficiency 3-port diffraction grating. In contrast to a conventional transmissive coupling component, such an all-reflective coupler avoids all thermal effects that are associated with light absorption in the substrate. An all-refl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Applied optics
دوره 39 25 شماره
صفحات -
تاریخ انتشار 2000