Photoreflectance spectroscopy with white light pump beam
نویسندگان
چکیده
Using a dual chopping scheme where both the pump beam and the probe beam are chopped, we show that it is possible to perform photoreflectance spectroscopy with a broadband white light source as the pump beam instead of a laser source. We show that although the signal strength is reduced by a factor of 1/p in the dual chopping scheme, it nevertheless has several advantages. A white light pump beam provides a wide range of excitation energy values, enabling one to characterize semiconductors of different band gaps spread over a wide energy range with a single modulation source. In the case of semiconductor heterostructures, simultaneous as well as selective excitation of different interfaces can be achieved easily. This technique is not plagued by the problem of background due to luminescence often encountered in low-temperature photoreflectance measurements. In this article, we present the details of this technique and demonstrate its usefulness by applying it to selected semiconductor heterostructure samples. © 1998 American Institute of Physics. @S0034-6748~98!00503-6#
منابع مشابه
Interference effects in electromodulation spectroscopy applied to GaAs-based structures: A comparison of photoreflectance and contactless electroreflectance
In this letter, we show that the oscillation features sOFsd usually observed in photoreflectance sPRd spectra of GaAs-based structures grown on the n-type GaAs substrate below the GaAs fundamental gap could be eliminated completely by applying the contactless electroreflectance sCERd instead of PR. This finding confirms that the origin of OFs is the modulation of the refractive index in the sam...
متن کاملPhotoreflectance Study of Electric Field Distributions in Semiconductors Heterostructures Grown on Semi-Insulating Substrates
We have studied the photoreflectance (PR) spectra from a MBE grown heterostructure consisting of 200 nm of Gao.s3A10.~7As, a 800 nm GaAs buffer layer on a semi-insulating (100) LEC GaAs substrate. By varying both the pump beam wavelength and modulation frequency (up to 100 kHz) we are able to identify the component layers, their quality and the properties of the various interfaces. In this stud...
متن کاملWave optics version of photoreflectance signal formation in thermal wave experiments with solids
A common approach to the determination of the photoreflectance signal within the framework of wave optics is developed. It is shown that different modes of operation of the thermal wave photoreflectance microscope are possible. In recent years there has been increasing interest in the development and application of a photoreflectance thermal wave method. It has been successfully used as a power...
متن کاملSpecial effects of 3D diffusion of plasma waves : non linear photoreflectance signal
Increasing the photon flux of the pump beam can lead to non linearities in the photoreflectance signal of semiconductor samples. We will show that it is more difficult to obtain the non-linear regime in the case of three dimensional diffusion than in the monodimensional case. This observation adds credit to our model which assumes that non-linear effects observed are due to Auger recombination.
متن کاملOvercoming Difficulties in Photoreflectance Measurements on Product HBTs
Photoreflectance (PR) is an optical measurement technique used to study material properties and device structures. It is uniquely able to non-destructively measure electric fields within devices. Some device structures such as HBTs have a rough highly doped InGaAs surface layer. In some cases the surface roughness is sufficient to produce light scattering that impedes optical measurements such ...
متن کامل