High-Temperature Sensor Based on Fabry-Perot Interferometer in Microfiber Tip
نویسندگان
چکیده
A miniaturized tip Fabry-Perot interferometer (tip-FPI) is proposed for high-temperature sensing. It is simply fabricated for the first time by splicing a short length of microfiber (MF) to the cleaved end of a standard single mode fiber (SMF) with precise control of the relative cross section position. Such a MF acts as a Fabry-Perot (FP) cavity and serves as a tip sensor. A change in temperature modifies the length and refractive index of the FP cavity, and then a corresponding change in the reflected interference spectrum can be observed. High temperatures of up to 1000 °C are measured in the experiments, and a high sensitivity of 13.6 pm/°C is achieved. This compact sensor, with tip diameter and length both of tens of microns, is suitable for localized detection, especially in harsh environments.
منابع مشابه
Intrinsic Fabry-Perot Interferometeric Sensor Based on Microfiber Created by Chemical Etching
An intrinsic Fabry-Perot interferometeric sensor based on a microfiber has been demonstrated. The micro-size suspended core is created by chemical etching a photonics crystal fiber, of which the cladding has a micrometer-spaced, hexagonal array of air holes. The sensing head is fabricated by chemical etching a short section of photonics crystal fiber spliced with a single mode fiber. The temper...
متن کاملLow-Cost Fiber-Tip Fabry-Perot Interferometer and Its Application for Transverse Load Sensing
A Fabry-Perot interferometer sensor based on a fiber-tip bubble-structure micro-cavity is proposed, fabricated, and demonstrated for transverse load sensing. The micro-cavity is fabricated by using arc discharge at the end of a multimode fiber which has been processed with chemical etching. A transverse load sensitivity of 3.64 nm/N and a relative low temperature sensitivity of about 2 pm/◦C ar...
متن کاملChitosan Layer Fabry - Perot Interferometer - Based Optical Fiber Sensor for Cadmium Ion Detection
Optical sensors based on Fabry-Perot interferometer to detect cadmium ions is proposed. The sensor was fabricated by coating the tip of the optical fiber by chitosan. The two chitosan surfaces serve as mirrors which form a Fabry-Perot interferometer. The characterization results indicate that the sensor has a linear response with sensitivity of 0.0884 dBm/ppm with a correlation factor of 0.9665...
متن کاملSub-micron silica diaphragm-based fiber-tip Fabry-Perot interferometer for pressure measurement.
We demonstrate a sub-micron silica diaphragm-based fiber-tip Fabry-Perot interferometer for pressure sensing applications. The thinnest silica diaphragm, with a thickness of ∼320 nm, has been achieved by use of an improved electrical arc discharge technique. Such a sub-micron silica diaphragm breaks the sensitivity limitation imposed by traditional all-silica Fabry-Perot interferometric pressu...
متن کاملHigh-pressure and high-temperature characteristics of a Fabry-Perot interferometer based on photonic crystal fiber.
A fiber-optic Fabry-Perot interferometer was constructed by splicing a short length of photonic crystal fiber to a standard single-mode fiber. The photonic crystal fiber functions as a Fabry-Perot cavity and serves as a direct sensing probe without any additional components. Its pressure and temperature responses in the range of 0-40 MPa and 25°C-700°C were experimentally studied. The proposed ...
متن کامل