Noise in Current-Commutating CMOS Mixers
نویسندگان
چکیده
A noise analysis of current-commutating CMOS mixers, such as the widely used CMOS Gilbert cell, is presented. The contribution of all internal and external noise sources to the output noise is calculated. As a result, the noise figure can be rapidly estimated by computing only a few parameters or by reading them from provided normalized graphs. Simple explicit formulas for the noise introduced by a switching pair are derived, and the upper frequency limit of validity of the analysis is examined. Although capacitive effects are neglected, the results are applicable up to the gigahertz frequency range for modern submicrometer CMOS technologies. The deviation of the device characteristics from the ideal square law is taken into account, and the analysis is verified with measurements.
منابع مشابه
A transformer based 1.8-GHz low-IF receiver for 1V in 0.13-μm CMOS
A fully integrated low-IF receiver for 1.8GHz in 0.13-μm CMOS is presented. The receiver consists of a VCO, an IQ-divider, an LNA, and a double balanced IQ-mixer. The RF input stage and the commutating stage of the IQ-mixer are current coupled via an on-chip transformer which is operating in resonant mode and is performing a current gain. A design method is presented to reduce the input impedan...
متن کاملHigh-Frequency Noise in RF Active CMOS Mixers
A new analytical model for high-frequency noise in RF active CMOS mixers such as single-balanced and doublebalanced architectures is presented. The analysis includes the contribution of non-white gate-induced noise at the output as well as the spot noise figure (NF) of the RF CMOS mixer, while accounting for the non-zero correlation between the gateinduced noise and the channel thermal noise. T...
متن کاملIEEE Paper Template in A4 (V1)
In this paper a 3.5 GHz down conversion mixer with 20 MHz IF output signal for location-fixed WiMAX systems is presented. The proposed mixer is implemented with TSMC 0.18μm RF CMOS technology with 1.5V supply voltage which utilizes Current-Bleeding and Current-Reuse techniques to improve noise figure and conversion gain of conventional Gilbert-type structure. This mixer achieves 12 dB of conver...
متن کاملTo study and analyse Mixers under CMOS Technology
In this paper various mixers are defined for CDMA applications . Using CMOS makes easier for mixers to act on same chip with other digital and analog circuits . The topologies we are defining are dual gate mixers , back gate mixers, single balanced current switching mixers and back end mixers . The backgate mixer utilizes the inherent lateral bipolar transistor in CMOS. Device simulations were ...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کامل