A 2-16 GHz CMOS Current Reuse Cascaded Ultra- wideband Low Noise Amplifier
نویسندگان
چکیده
This paper presents the design of a 2-16 GHz ultra wide band low noise amplifier (UWB LNA). The proposed LNA has a gain of 11.5 ± 0.85 dB with NF less than 2.82 dB. Good input and output impedance matching, good isolation and linearity are achieved over the operating frequency band. The proposed UWB LNA consumes 18.14 mW of power from 1.8V supply. This UWB LNA is designed and simulated in 0.18 μm CMOS process. Keywordslow noise amplifier (LNA), ultra wideband(UWB), Noise Figure (NF).
منابع مشابه
A New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملA High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملA 0.13μm CMOS Low-Noise Amplifier Using Resistive Feedback Current Reuse Technique for 3.1-10.6 GHz Ultra-Wideband Receivers
Department of Physics and Electronics, University of Science-VNU Hochiminh City, Vietnam; Faculty of Electrical and Electronics Engineering, University of Technology, VNU Hochiminh City, Vietnam; Department of Electrical and Computer Engineering, University of Saskatchewan, Saskatoon, Canada Corresponding Author: Nhan Nguyen ______________________________________________________________________...
متن کاملA 3-6 GHz Current Reused Noise Canceling Low Noise Amplifier for WLAN and WPAN Applications
ISSN: 2347-8578 www.ijcstjournal.org Page 315 A 3-6 Ghz Current Reuse Noise Cancelling Low Noise Amplifier For WLAN And WPAN Application Shivabhakt Mhalasakant Hanamant [1], Dr.S.D.Shirbahadurakar [2] M.E Student , Guide [2] Department of E & TC Dr. D.Y.Patil COE, Ambi Pune – India ABSTRACT A wideband low-noise amplifier (LNA), which is a key block in the design of broadband receivers for multi...
متن کامل