A Classification of Reversible Bit and Stabilizer Operations
نویسندگان
چکیده
This thesis is an exposition of a classification of classical reversible gates acting on bits in terms of the reversible transformations they generate, which was recently completed by the author, Scott Aaronson, and Luke Schaeffer. In particular, we present those portions of the classification which were the main contributions of the author. Most importantly, this thesis contains the proof that every non-affine gate generates a Fredkin gate, which was one of the main technical hurdles in completing the classification. Our classification can be seen as the reversible-computing analogue of Post's lattice, a central result in mathematical logic from the 1940s, where we allow arbitrary ancilla bits to be used in the computation provided they return to their initial configuration at the end of the computation. It is a step toward the ambitious goal of classifying all possible quantum gate sets acting on qubits. This thesis also gives preliminary results for the classification of stabilizer gates, which have garnered much attention due to their role in unifying many of the known quantum error-correcting codes. In the stabilizer setting, we generalize the classical model to allow the use of arbitrary stabilizer ancillas and show that this leads to several nonintuitive results. In particular, we show that the CNOT and Hadamard gates suffice to generate all stabilizer operations (whereas the phase gate is required in a more group theoretic setting); present a complete classification of the "classical" stabilizer operations; and give exact generating sets for the one-qubit stabilizer operations. Thesis Supervisor: Scott Aaronson Title: Professor of Electrical Engineering and Computer Science
منابع مشابه
Design of Continuous Gauge Near-Bit Stabilizer, Using Optimized Hydraulics and Gauge Geometry in Mishan andAghajari Formation
The main task of drilling the formation by the bit is done via scraping, crushing and grinding. Discharging the fluid from the bit nozzles is done with high pressure which assists to break the rocks. Different parameters affect the bit selection and design for each drilling formation, but the most important one is drillability that depends on hardness of the formation. In this paper, the design...
متن کاملThe Classification of Stabilizer Operations over Qubits
We present a complete classification of quantum stabilizer gates in terms of the functions they generate assuming the ability to swap qubits and use ancillary workspace. Because we view these stabilizer circuits as subroutines of some general quantum computation, we insist that any ancilla qubits used during the computation must not change in an input-dependent manner. This is the first attempt...
متن کاملUsing an experimental drilling simulator to study operational parameters in drilled-cutting transport efficiency
Inadequate hole cleaning can lead to many problems in horizontal and directional wells. In this work, we tried to investigate the cutting transport phenomenon by an experimental directional drilling simulator, considering the differences between the operational and experimental conditions. The inclination, fluid type (water, foam, viscous, and dense), rotary speed (0 and 110 rpm), nozzle bit si...
متن کاملA Novel Design of Reversible Multiplier Circuit (TECHNICAL NOTE)
Adders and multipliers are two main units of the computer arithmetic processors and play an important role in reversible computations. The binary multiplier consists of two main parts, the partial products generation circuit (PPGC) and the reversible parallel adders (RPA). This paper introduces a novel reversible 4×4 multiplier circuit that is based on an advanced PPGC with Peres gates only. Ag...
متن کاملInvestigation of Thermal Operational Regimes for Diamond Bit Drilling Operations (TECHNICAL NOTE)
This paper reviews existing studies and investigates thermal operational regimes of diamond bit during drilling operations. The operating temperature of the diamond core drill is studied under bench condition and an optimal thermal range are presented. Based on this study, it was noted that glazing of diamond tools is observed at temperatures less than 327°C, and normal wear of diamond tools is...
متن کامل