Fabrication of Alternating-Phase Fed Single-Layer Slotted Waveguide Arrays Using Plastic Materials with Metal-Plating

نویسندگان

  • Miao Zhang
  • Jiro Hirokawa
  • Makoto Ando
چکیده

Lightweight single-layer slotted waveguide array antennas are fabricated using plastic materials with metal-plating. A plastic material that has good heat-radiation properties is investigated. Three types of antennas are fabricated by milling, using ABS resin, heat-radiating plastic, and aluminum alloy. In measurements, all three types of antennas are confirmed to have almost the same VSWR and gain in the 25 GHz frequency band. key words: fixed wireless access (FWA), slotted waveguide array, plastic material, metal-plating

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An Alternating-Phase Fed Single-Layer Slotted Waveguide Array with a Sector Shaped Beam for Millimeter-Wave Radar Applications

This paper presents design of an alternating-phase fed single-layer slotted waveguide array for a sector shaped beam in the Eplane radiation pattern. A sector beam pattern is very effective for radar applications for detecting obstacles in a certain angular range without mechanical or electronic scanning. The sector shaped beam with 13 degree beam width is synthesized by a cascade of T-junction...

متن کامل

Mechanical Phase Shift by Moving a Dielectric Block in the Divider for Single-layer Slotted Waveguide Arrays

1. Introduction This paper proposes beam scan by moving dielectric blocks mechanically in the feed waveguide of single-layer slotted waveguide arrays as shown in Fig.1. Millimeter-wave antennas with beam scan are desired in various systems such as collision-avoidance car radars [1-3]. Electrical scanning is the best but mechanical one is still attractive in terms of cost, efficiency, heat-radia...

متن کامل

An E-Band Partially-Corporate Feed Slot Array with Laminated Quasi Double-Layer Waveguide Structure and PMC Terminations

Authors have developed various types of single-layer slotted waveguide arrays with simple structure and high mass-productivity. Those arrays have been successfully applied to relatively narrowband commercial services for satellite broadcast reception in 12 GHz band and wireless IP access at home in 26 GHz band etc. However, one weak point of that antenna is that the bandwidth of the antenna gai...

متن کامل

Design Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays

In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...

متن کامل

Design of a Double-Layer Slotted Waveguide Array with a Partially Corporate Feed Circuit Installed in the Bottom Layer and its Fabrication by Diffusion Bonding of Laminated Thin Plates in 38GHz Band

This paper is to demonstrate the potential and realizability of a high-performance waveguide slot antenna. A double-layer slotted waveguide array with a partially corporate feed circuit installed in the bottom layer is proposed and designed in 38GHz band to realize broadband characteristics. For the antenna realization, a diffusion bonding of laminated thin plates is introduced as the fabricati...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • IEICE Transactions

دوره 91-B  شماره 

صفحات  -

تاریخ انتشار 2008