Hydrogen passivation of Se and Te in AlSb.
نویسندگان
چکیده
Using infrared absorption spectroscopy we have observed local vibrational modes ~LVM’s! arising from DX-hydrogen complex in AlSb. Hydrogen was diffused into bulk AlSb:Se and AlSb:Te by annealing in sealed quartz ampoules with either hydrogen gas or methanol ~CH3OH!. The persistent photoabsorption of the DX-like Se donor is significantly reduced after hydrogenation. In hydrogenated AlSb:Se, we attribute the LVM peaks at 1608.6 and 1615.7 cm to hydrogen stretch modes. Deuterated AlSb:Se has only one stretch mode at 1173.4 cm. The second, third, and fourth harmonics of the wag modes are observed and show splittings consistent with C3v symmetry. In AlSb:Te, we find a hydrogen stretch mode at 1599.0 cm 21 and a deuterium mode at 1164.4 cm. We propose a model in which the hydrogen attaches to an aluminum in a @111# antibonding orientation. @S0163-1829~96!04824-2#
منابع مشابه
Pressure dependence of donor excitation spectra in AlSb
We have investigated the behavior of groundto bound excited-state electronic transitions of Se and Te donors in AlSb as a function of hydrostatic pressure. Using broadband far-infrared Fourier transform spectroscopy, we observe qualitatively different behaviors of the electronic transition energies of the two donors. While the pressure derivative of the Te transition energy is small and constan...
متن کاملHydrogen in compound semiconductors
Hydrogen can be inadvertently introduced at any of several steps in the fabrication of optoelectronic devices. The most common consequence of hydrogenation is the passivation of dopant impurities, which leads to a decrease in the electrical conductivity of the material. The most successfully applied experimental technique for directly determining the involvement of hydrogen has been infrared-ab...
متن کاملAnalysis of Te and TeO2 on CdZnTe Nuclear Detectors Treated with Hydrogen Bromide and Ammonium-Based Solutions
Surface defects caused during cutting and polishing in the fabrication of cadmium zinc telluride (CdZnTe) nuclear detectors limit their spectral performance. Chemical treatments are often used to remove surface damages and defects. In this paper, we present the analysis of Te and TeO2 species on the surfaces of CdZnTe nuclear detectors treated with hydrogen bromide and ammonium-based solutions....
متن کاملRemoval of Te and Se anions in alkaline media in presence of cyanide by quaternary ammonium salts
Precious metals are currently associated with selenium (naumannite, Ag2Se) and tellurium (calaverite, AuTe2; sylvanite, (Au,Ag)2Te4) to form species refractory to cyanidation. The aim of this preliminary work was to study the use of the solvent extraction technique to recover tellurium and selenium ions from a synthetic solution similar to the cyanidation effluents to recycle the free cyanide b...
متن کاملAb initio study of the Surface Passivation influence on electronic and optical Properties of (001) SbNSr3 anti-perovskite Surface
In this research, the electronic and optical properties of the (001) surface of SbNSr3 with SbSr and NSr2 terminations and surface passivation impact on electronic properties were investigated. The calculations were done within density functional theory and using pseudo-potential method. HSE hybrid functional was used for exchange correlation potential. The surface calculations were performed t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Physical review. B, Condensed matter
دوره 53 24 شماره
صفحات -
تاریخ انتشار 1996