Single Stage Techniques for Power Factor Correction
نویسندگان
چکیده
Medium and high power switch mode power supplies SMPS (>500W) used in telecommunications stations are normally based on the full-bridge DC-DC converter with isolation transformer. According to the transistors states, the full-bridge converter allows four different switching sates which can be used to control the output voltage of the SMPS, and to perform the power factor corrector (PFC) function simultaneously. This paper presents the techniques and the control strategies used to guarantee the control of both conversion process, i.e., output voltage regulation and input current wave shaping to provide PFC, previously referred. Experimental results of two single-stage DC-DC full-bridge topologies with PFC are also presented, in order to verify their higher performance.
منابع مشابه
An Isolated Off-Line High Power Factor Electrolytic Capacitor-Less LED Driver with Pulsating Output Current
One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is the electrolytic capacitor. An isolated off-line LED driver is proposed in this paper, in which ...
متن کاملA New Approach for Reactive Power Control of Single Phase Transformerless Inverter to Modify Power Quality in Stand Alone Micro-Grids with Current Leakage Elimination
Nowadays there has been an increasing interest in transformerless inverter for grid-connected photovoltaic (PV) system due to low cost, high efficiency and light weight. One of the reasons describe the grid behavior is capability of reactive power control by inverter. According to the standard VDE-AR-N 4105, grid-tied PV inverter of power rating below 3.68KVA, should attain power factor (PF) fr...
متن کاملFlyback with Half Wave Rectifier for Single Stage Power Factor Correction
The flyback converter type single-stage converter and a half wave rectifier with time-multiplexing control (TMC) for power factor correction is proposed. It has the advantage of better magnetic core utilization and better performance for high power applications. The major portion of the input is transferred to the load through ac-dc conversion. And the part of the input power is delivered to th...
متن کاملHopf bifurcation as an Intermediate-Scale Instability in Single-Stage Power-Factor-Correction Power supplies: Analysis, Simulations and Experimental Verification
This paper reports intermediate-scale instability in a single-stage power-factor-correction (PFC) power supply that employs a cascade configuration of a boost stage operating in discontinuous conduction mode (DCM) and a forward stage operating in continuous conduction mode (CCM). The two stages combine into a single stage by sharing one main switch and one control loop to achieve input PFC and ...
متن کاملModified Bi-directional AC/DC Power Converter with Power Factor Correction
Most existing power converters and industrial motor drive systems draw non-sinusoidal currents from the supply. Non-sinusoidal currents contained harm harmonics disturb the power supply which it causes serious concern for reliability. Other equipments that use the same power supply are adversely affected. This paper suggests the operation and performance of a new modified AC/DC converter that ...
متن کامل