An Improved Radar ECCM Method Based on Orthogonal Pulse Block and Parallel Matching Filter

نویسندگان

  • Ahmed Abdalla Ali
  • Yuan Zhao
  • Mohammed Ramadan
  • Bin Tang
چکیده

—In this paper, a Radar Electronic Counter Countermeasure (ECCM) scheme is considered to enhance the concept of pulse diversity which makes use of the orthogonal pulse block code. This is achieved by employing all the received signals in the matching filter operation at slow-time intervals based on parallel matching filters, which improves the Signal to Noise Ratio (SNR) of real targets. This algorithm has been verified by simulations.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Extending the Radar Dynamic Range using Adaptive Pulse Compression

The matched filter in the radar receiver is only adapted to the transmitted signal version and its output will be wasted due to non-matching with the received signal from the environment. The sidelobes amplitude of the matched filter output in pulse compression radars are dependent on the transmitted coded waveforms that extended as much as the length of the code on both sides of the target loc...

متن کامل

A New Method for Ground Moving Targets Tracking Using Radar Based on Compressed Sensing

In this paper, we propose a Compressed Sensing (CS) based method under the unknown sparse degree to track ground moving targets using Pulse-Doppler (PD) radar. We use the sparsity of delay-Doppler plane in the process of disposing PD radar echo to set up a sparse signal model in each pulse interval. At the state prediction stage, we can get the predicted values of target states by dynamic equat...

متن کامل

A Design of the Matched Filter for the Passive Radar Sensor

This paper discusses a method of designing a matched filter for a passive microwave sensor. This sensor receives pulse signals transmitted by a target active radar. Received signals can be categorized into two types due to either the pulse signals or noise. The method first estimates an autocorrelation function of the received signals. The autocorrelation of the pulse signals is then extracted ...

متن کامل

Tracking Radar Digital Matched-Filter ASIC Design

Matched-filter is widely used in real time signal processing, especially in Radar Signal Processing. This paper provides a novel structure of digital matched-filter used in tracking radar system. This design applies block-floating-point arithmetic to improve the precision. The whole digital matched-filter is implemented in only one chip of FPGA. This ASIC has two work modes: 512 points pulse co...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • JCM

دوره 10  شماره 

صفحات  -

تاریخ انتشار 2015