The Limiting Temperature of hot nuclei from microscopic Equation of State
نویسندگان
چکیده
The limiting temperature T lim of a series of nuclei is calculated employing a set of microscopic nuclear Equations of State (EoS). It is shown that the value of T lim is sensitive to the nuclear matter Equation of State used. Comparison with the values extracted in recent phenomenological analysis appears to favour a definite selection of EoS' s. On the basis of this phenomenologi-cal analysis, it seems therefore possible to check the microscopic calculations of the nuclear EoS at finite temperature, which is hardly accessible through other experimental informations.
منابع مشابه
Characteristic Points of Stress-Strain Curve at High Temperature
Determination of critical points on hot stress-strain curve of metals is crucial in thermo-mechanical processes design. In this investigation a mathematical modeling is given to illustrate the behavior of metal during hot deformation processes such as hot rolling. The critical strain for the onset of dynamic recrystallization has been obtained as a function of strain at the maximum stress. In a...
متن کاملVolumetric properties of high temperature, high pressure supercritical fluids from improved van der Waals equation of state
In the present work, a modified equation of state has been presented for the calculation of volumetric properties of supercritical fluids. The equation of state is van der Waals basis with temperature and density-dependent parameters. This equation of state has been applied for predicting the volumetric properties of fluids. The densities of fluids were calculated from the new equation of state...
متن کاملDynamic recrystallization kinetics of AISI 403 stainless steel using hot compression test
In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...
متن کاملPrediction of Work-Piece Constitutive Equation in Hot Rolling of Strip
Dimensional control of the work-piece in steel industry is of important interest. The main aspects in overcoming the thickness control are variations in material strength due to variations in chemical composition, work-piece temperature, reduction and the strain rate applied to the work-piece. In this paper based on the main parameters affecting the rolling force an attempt been made to give a ...
متن کاملTemperature-Dependent Dispersion Coefficients of Alkali Metals Using Equation of State
In this study, a temperature-dependent of the dispersion coefficients is calculated from equation state.The Lennard-Jones LJ (12-6-3) effective pair potential function and simple thermodynamic argumentwith the input PVT data of liquid metals are used to calculate the dispersion coefficients. The dispersioncoefficients ( , , ) 3 6 12 C C C are found to be a linear function of 1/T1+α , where T is...
متن کامل