Power Supply Noise Reduction
نویسنده
چکیده
Originally written in 1979, with modest updates in 1981 and 2002. Last updated on May 11, 2006. You can find the most recent version at www.designers-guide.org. Contact the author via e-mail at [email protected]. Permission to make copies, either paper or electronic, of this work for personal or classroom use is granted without fee provided that the copies are not made or distributed for profit or commercial advantage and that the copies are complete and unmodified. To distribute otherwise, to publish, to post on servers, or to distribute to lists, requires prior written permission.
منابع مشابه
Low Dropout Based Noise Minimization of Active Mode Power Gated Circuit
Power gating technique reduces leakage power in the circuit. However, power gating leads to large voltage fluctuation on the power rail during power gating mode to active mode due to the package inductance in the Printed Circuit Board. This voltage fluctuation may cause unwanted transitions in neighboring circuits. In this work, a power gating architecture is developed for minimizing power in a...
متن کاملStub vs. Capacitor for Power Supply Noise Reduction
This paper compares a stub and a decoupling capacitor for power supply noise reduction. A quarter-length stub attached to the power supply line of an LSI chip works as a band-eliminate filter, and suppresses the power supply bounce of the designed frequency. The conditions where the stub is more effective than the same-area decoupling capacitor are clarified. The stub will work more efficiently...
متن کاملPreliminary Experiments for Power Supply Noise Reduction Using On-Board Stubs
This paper demonstrates a power supply noise reduction using on-board stubs. A quarter-length stub attached to the power supply line of an LSI chip works as a band-eliminate filter, and suppresses the power supply noise of the designed frequency. Preliminary experiments show that 87% of the designed frequency noise component is suppressed when stub patterns are written on a power supply area on...
متن کاملA 1V Supply Low Noise CMOS Amplifier Using Noise Reduction Technique of Autozeroing and Chopper Stabilization
A low-noise CMOS amplifier operating at a 1-V supply voltage is developed using the two noise reduction techniques of autozeroing and chopper stabilization. The proposed amplifier utilizes a feedback with virtual grounded input-switches and a multiple-output switched op-amp. The low-noise amplifier fabricated by a 0.18-μm CMOS technology was measured at a 1-V power supply, and achieved low nois...
متن کاملAnalysis and Performance Evaluation of Noise-Reduction Transformer
The present paper deals with the analysis and development of noise-reduction transformer that has a filter function for conductive noise transmission. Two types of prototype noise-reduction transformers with two different output voltages are proposed. To determine an optimum design for the noise-reduction transformer, noise attenuation characteristics are discussed based on the experiments and ...
متن کاملMulti-Story Power Delivery for Supply Noise Reduction and Ultra Low Voltage Operation
This paper presents a multi-story power delivery scheme which shows significant reduction of supply noise and power consumption compared to conventional power delivery scheme. To maximize the effectiveness of the proposed scheme, a digital voltage regulator is designed to balance the current dissipation of circuits in different voltage domains. Data transfer circuits based on capacitive couplin...
متن کامل