High quality AlGaN epilayers grown on sapphire using SiNx interlayers
نویسندگان
چکیده
We have investigated the optimization of Al0.2Ga0.8N layers directly grown on sapphire by metalorganic vapor phase epitaxy (MOVPE). The quality of the AlGaN epilayers was improved by in situ nano-masking employing ultra-thin SiNx interlayers. Transmission electron microscopy (TEM) investigations reveal an enormous reduction of edge-type dislocations by SiNx nano-masking. Furthermore, formation of bundles of dislocations converging to the surface is visible, leading to large areas up to 1mm in size on the surface which are almost defect free. The SiNx surface coverage was carefully optimized resulting in narrower (1 0 2)-reflections of high resolution X-ray diffraction (HRXRD), down to full width at half maximum (FWHM) values of 570 arcsec, in addition to narrow symmetric HRXRD reflections down to FWHM of 150 arcsec. Structures with double SiNx interlayer revealed even higher quality of the epilayers with a FWHM of 440 arcsec for the (1 0 2)-reflection. A series of GaN–AlGaN multi-quantum wells were grown on such high quality templates. The MQWs show a significant decrease in peak widths and also an increase in the luminescence intensity. Furthermore, these templates have been used as buffer layers for ultraviolet light-emitting diodes emitting at 350nm. & 2010 Elsevier B.V. All rights reserved.
منابع مشابه
In-situ deposited SiNx nanomask for crystal quality improvement in AlGaN
We report the growth of high crystal quality Al0.3Ga0.7N directly on sapphire substrates with metalorganic vapour phase epitaxy. We studied the improvements in crystal quality by introducing an in-situ deposited SiNx interlayer. It acts as a nanomask which results in termination of the dislocations near the interface between the nanomask and epilayer. The epilayers with no SiNx interlayer have ...
متن کاملTEM investigations on growth interrupted samples for the correlation of the dislocation propagation and growth mode variations in AlGaN deposited on SiNx interlayers
Threading dislocations (TDs) can be reduced by in-situ deposition of intermediate SiNx sub-monolayers in group III-nitride heterostructures and their ternary alloys. Here we observe efficient dislocation density decreasing at the SiNx nano-mask in an AlxGa1 xN layer with x1⁄40.2 grown epitaxially on c-plane sapphire by low pressure MOVPE. However we did not achieve high annihilation efficiency ...
متن کاملSimulation supported analysis of the effect of SiNx interlayers in AlGaN on the dislocation density reduction
In the last few years aluminium nitride (AlN) has attracted much attention due to its extremely large direct band gap of approximately 6.0 eV and its impressive chemical and thermal stability. Thus AlN and AlxGa1-xN ternary alloys are promising materials for high-power high temperature electronic applications and optoelectronic devices in UV range. For group-III nitride wafers are still not ava...
متن کاملEfficient 350 nm LEDs on low edge threading dislocation density AlGaN buffer layers
Improving the crystal quality of AlGaN epitaxial layers is essential for the realization of efficient III-nitride-based light emitting diodes (LEDs) with emission wavelengths below 365 nm. Here, we report on two different approaches to improve the material quality of AlGaN buffer layers for such UV-LEDs, which are known to be effective for the MOVPE growth of GaN layers. Firstly, we grew AlGaN ...
متن کاملReduction of Defects in AlGaN Grown on Nanoscale-Patterned Sapphire Substrates by Hydride Vapor Phase Epitaxy
In this study, a 3-μm-thick AlGaN film with an Al mole fraction of 10% was grown on a nanoscale-patterned sapphire substrate (NPSS) using hydride vapor phase epitaxy (HVPE). The growth mechanism, crystallization, and surface morphology of the epilayers were examined using X-ray diffraction, transmission electron microscopy (TEM), and scanning electron microscopy at various times in the growth p...
متن کامل