Fluid Forming – Hydroforming with Rexroth Maximum Precision with Single-Component Forming
ثبت نشده
چکیده
منابع مشابه
Loading Path Determination for Tube Hydroforming Process of Automotive Component Using APDL
In this study, an extended stress-based forming limit diagram (FLD) for prediction of necking based on the Marciniak and Kucznski (M-K) model is represented and applied in tube hydroforming. The bulge forming of a straight tube is simulated by finite element method and verified with published experimental data. This adaptive simulation technique is based on the ability to detect the onset an...
متن کاملImprovement of Die Corner Filling of Stepped Tubes Using Warm Hybrid Forming
Aluminum and magnesium alloys are of materials for decreasing vehicle weight and consequently reducing fuel consumption. However, forming limitations regarding their low formability at room temperature are found when being manufactured by conventional forming processes. For this reason, development of new forming techniques, such as warm tube hydroforming, is needed to overcome such limitations...
متن کاملInvestigation of the Effects of Pressure Path and Tool Parameters in Hydrodynamic Deep Drawing
In recent years, hydroforming process has been applied in different industries such as aerospace, automotive and military industries due to its advantages, such as high dimensional accuracy, capability of forming complicated parts and high drawing ratio. Hydrodynamic deep drawing with radial pressure is one type of hydroforming process. In this paper, forming of cylindrical cups in hydrodynamic...
متن کاملFinite element comparison of single, bi-layered and three-layered tube hydroforming processes
In this paper, single, bi-layered and three-layered tube hydroforming processes were numerically simulated using the finite element method. It was found that the final bulges heights resulted from the models were in good agreement with the experimental results. Three types of modeling were kept with the same geometry, tube material and process parameters to be compared between the obtained hydr...
متن کاملSimultaneous hydroforming of bulge- and T-zone in 304 stainless steel and 70/30 brass tubes
Hydroforming process is largely used for the production of tubular parts in various industries, and has advantages such as less weight, higher quality, more strength and fewer production cost compared to the conventional methods of production. The aim of this study is forming a tube-shaped part with a special geometry that has both bulge- and T-zones with tube hydroforming process. The forming ...
متن کامل