Spatial Power Combining Amplifier for Ground and Flight Applications
نویسندگان
چکیده
منابع مشابه
Non-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کاملEffective Design of a 3×4 Two Dimensional Distributed Amplifier Based on Gate Line Considerations
In this paper two dimensional wave propagation is used for power combining in drain nodes of a distributed amplifier (DA). The proposed two dimensional DA uses an electrical funnel to add the currents of drain nodes. The proposed structure is modified due to gate lines considerations. Total gain improvement is achieved by engineering the characteristic impedance of gate lines and also make appr...
متن کاملA Low-Voltage, Low-Power, Two-Stage Amplifier for Switched-Capacitor Applications in 90 nm CMOS Process
Abstract- A novel low-voltage two-stage operational amplifier employing resistive biasing is presented. This amplifier implements neutralization and correction common mode stability in second stage while employs capacitive dc level shifter and coupling between two stages. The structure reduces the power consumption and increases output voltage swing. The compensation is performed by simple mill...
متن کاملA 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure
Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...
متن کاملDesign of an Efficient Circuit for Data Rate Configuration in Power Amplifier Dedicated to Wireless Medical Applications
This paper presents a new circuit to configure power amplifier (PA) for return-to-zero on-off-keying (RZ-OOK) transmitters. The proposed PA works as a multimode structure with configurable data rate and output power. The programmable data rate function is achieved by duty cycle adjustment of input data and producing input RZ-data by a simple circuit, which leads to a linear scale of data rate w...
متن کامل