Model Reconstruction Using POD Method for Gray-box Fault Detection12

نویسندگان

  • Han G. Park
  • Michail Zak
چکیده

This paper describes using Proper Orthogonal Decomposition (POD) method to create low-order dynamical models for the Model Filter component of Beacon-based Exception Analysis for Multi-missions (BEAM). The POD modeling procedure is described, and its usefulness in creating simple low-order dynamical models of a complex system. The POD procedure will be shown on an example problem of a Burgers’ Equation. It will be demonstrated that stable low-order dynamical models can be created even in the presence of noise commonly found in experimental data.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Adaptive and intelligent control of permanent magnet synchronous motor (PMSM) using a combination of fuzzy logic and gray wolf algorithm under fault condition

Nowadays, permanent magnet synchronous motors have been widely used in industry due to the elimination of excitation losses, longer life and higher efficiency. Errors in engine and drive systems are unavoidable during operation. Therefore, a suitable scenario should be considered for when these systems fail. If the necessary predictions and control algorithms are not considered for the error co...

متن کامل

An Unknown Input Observer for Fault Detection Based on Sliding Mode Observer in Electrical Steering Assist Systems

Steering assist system controls the force transfer behavior of the steering system and improves the steering probability of the vehicle. Moreover, it is an interface between the diver and vehicle. Fault detection in electrical assisted steering systems is a challenging problem due to frequently use of these systems. This paper addresses the fault detection and reconstruction in automotive elect...

متن کامل

A Gray-Box Neural Network Model of Parkinson’s Disease Using Gait Signal

In this study, we focused on the gait of Parkinson’s disease (PD) and presented a gray box model for it. We tried to present a model for basal ganglia structure in order to generate stride time interval signal in model output for healthy and PD states. Because of feedback role of dopamine neurotransmitter in basal ganglia, this part is modelled by “Elman Network”, which is a neural network stru...

متن کامل

Anomaly Detection with Diagnosis in Diversified Systems using Information Flow Graphs

Design diversity is a well-known method to ensure fault tolerance. Such a method has also been applied successfully in various projects to provide intrusion detection and tolerance. Two types of approaches have been investigated: the comparison of the outputs of the diversified services without any knowledge of the internals of the server (black box approach) or an intrusive observation of the ...

متن کامل

Using structural decomposition methods to design gray-box models for fault diagnosis of complex industrial systems: a beet sugar factory case study

Reliable and timely fault detection and isolation are necessary tasks to guarantee continuous performance in complex industrial systems, avoiding failure propagation in the system and helping to minimize downtime. Model-based diagnosis fulfils those requirements, and has the additional advantage of using reusable models. However, reusing existing complex non-linear models for diagnosis in large...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2003