Interpolative Control Structure Design for a Heat Exchanger in a Geothermal Power Plant
نویسندگان
چکیده
The paper presents the idea of replacing fuzzy controllers with interpolative ones in complicated control structures, in order to reduce the complexity of the structure, visible in implementation method and calculus time. There are presented main theoretical and procedural aspects related to design and implementation of interpolative controllers. As a study case an interpolative control structure for a heat exchanger is developed. Comparison with initial fuzzy system, demonstrate that interpolative controllers are able to bring better results and large design possibilities in control.
منابع مشابه
Modeling of a Geothermal Cycle Condenser in a Combined Diesel Power Cycle: Case Study of 42 MW Diesel Power Plant in Moghan and Ardabil
This paper presents the results of a research into the feasibility of recovering waste heat and determining design parameters of a recovery boiler for a set of medium-speed diesel generators with a capacity of 7 MW (the nominal capacity of all units is 42 MW, which would be a study on a unit). And is used to generate electricity. The main purpose of this study is to design a thermal waste recov...
متن کاملSiliceous scaling aspects of geothermal power generation using binary cycle heat recovery
Siliceous scaling potential of geothermal brines has long been an obstacle to the efficient energy recovery from some geothermal resources. In classical flash geosteam plant the brine for disposal was separated at high enough temperature in order to avoid ((silica oversaturation)) which might lead to scaling on hiher cooling for additional power generation through heat recovery. Recent years bi...
متن کاملConceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran
Conceptual design of a waste heat recovery cycle is carried out in attempt to enhance the thermal efficiency of a steam power plant. In the recovery system, super-critical an CO2 is employed as the working fluid operating in a Brayton cycle. Low grade heat rejected by the flue gases through the stack is used as the primary heat source, while a secondary heat exchanger utilizes th...
متن کاملSolar-Enhanced Air-Cooled Heat Exchangers for Geothermal Power Plants
This paper focuses on the optimization of a Solar-Enhanced Natural-Draft Dry-Cooling Tower (SENDDCT), originally designed by the Queensland Geothermal Energy Centre of Excellence (QGECE), as the air-cooled condenser of a geothermal power plant. The conventional method of heat transfer augmentation through fin-assisted area extension is compared with a metal foam-wrapped tube bundle. Both lead t...
متن کاملNumerical and Analytical Study of Natural Dry Cooling Tower in a Steam Power Plant
Design of a natural dry cooling tower has been accomplished in two sections: the design of heat exchangers and the numerical solution of flow through the tower. Heat exchanger (Heller type) has been simulated thermodynamically and then coupled with a computer program, which calculated the turbulent natural convection flow through the tower. The computer program developed for this purpose can be...
متن کامل