Advantages of Using a Two-Switch Forward in Single-Stage Power Factor Corrected Power Supplies
نویسنده
چکیده
منابع مشابه
Analysis and Design of a New Single Switch Non-Isolated Buck-Boost dc-dc Converter
In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In the presented converter, only one main switch is utilized. The proposed converter offers low v...
متن کاملTwo-Stage Inverter Based on Combination of High Gain DC-DC Converter and Five-Level Inverter for PV-Battery Energy Conversion
This paper proposes a new two-stage inverter based on transformer-less high gain DC-DC converter for energy conversion of a photovoltaic system. The designed system consists of a high gain DC-DC converter cascaded with a three-phase inverter. The proposed DC-DC converter has a simple structure, and it has one switch in its structure. The output voltage of the DC-DC converter supplies DC source ...
متن کاملHopf bifurcation as an Intermediate-Scale Instability in Single-Stage Power-Factor-Correction Power supplies: Analysis, Simulations and Experimental Verification
This paper reports intermediate-scale instability in a single-stage power-factor-correction (PFC) power supply that employs a cascade configuration of a boost stage operating in discontinuous conduction mode (DCM) and a forward stage operating in continuous conduction mode (CCM). The two stages combine into a single stage by sharing one main switch and one control loop to achieve input PFC and ...
متن کاملA Single Phase Single Stage AC/DC Converter with High Input Power Factor and Tight Output Voltage Regulation
A single stage single switch AC/DC converter is an integration of input current shaper and a DC/DC cell with a shared controller and one active switch. The converter is applicable for digital input power supply with high input power factor and tight output voltage regulation. The focus of the topology is to reduce the DC bus voltage at light load without compromising with input power factor and...
متن کاملSingle Stage Techniques for Power Factor Correction
Medium and high power switch mode power supplies SMPS (>500W) used in telecommunications stations are normally based on the full-bridge DC-DC converter with isolation transformer. According to the transistors states, the full-bridge converter allows four different switching sates which can be used to control the output voltage of the SMPS, and to perform the power factor corrector (PFC) functio...
متن کامل