A density functional theory for vapor-liquid interfaces using the PCP-SAFT equation of state.

نویسنده

  • Joachim Gross
چکیده

A Helmholtz energy functional for inhomogeneous fluid phases based on the perturbed-chain polar statistical associating fluid theory (PCP-SAFT) equation of state is proposed. The model is supplemented with a capillary wave contribution to the surface tension to account for long-wavelength fluctuations of a vapor-liquid interface. The functional for the dispersive attraction is based on a nonlocal perturbation theory for chain fluids and the difference of the perturbation theory to the dispersion term of the PCP-SAFT equation of state is treated with a local density approximation. This approach suggested by Gloor et al. [Fluid Phase Equilib. 194, 521 (2002)] leads to full compatibility with the PCP-SAFT equation of state. Several levels of approximation are compared for the nonlocal functional of the dispersive attractions. A first-order non-mean-field description is found to be superior to a mean-field treatment, whereas the inclusion of a second-order perturbation term does not contribute significantly to the results. The proposed functional gives excellent results for the surface tension of nonpolar or only moderately polar fluids, such as alkanes, aromatic substances, ethers, and ethanoates. A local density approximation for the polar interactions is sufficient for carbon dioxide as a strongly quadrupolar compound. The surface tension of acetone, as an archetype dipolar fluid, is overestimated, suggesting that a nonisotropic orientational distribution function across an interface should for strong dipolar substances be accounted for.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Modeling Solubility Behavior of CO2 in [C2-mim][BF4] and [C4-mim][BF4] Ionic Liquids by sPC-SAFT Equation of State

The simplified perturbed chain statistical associating fluid theory (sPC-SAFT) Equation of State (EOS) was proposed to describe the thermodynamic properties of pure ionic liquids (ILs). A set of sPC-SAFT parameters for 2 ILs was obtained by fitting the experimental liquid densities data over a wide range of temperature at atmospheric pressure. Good agreement with experimental density data was o...

متن کامل

Modeling thermodynamic properties of electrolytes: Inclusion of the mean spherical approximation (MSA) in the simplified SAFT equation of state

In this work, an equation of state has been utilized for thermodynamic modeling of aqueous electrolyte solutions. The proposed equation of state is a combination of simplified statistical associating fluid theory (SAFT) equation of state (similar to simplified PC-SAFT) to describe the effect of short-range interactions and mean spherical approximation (MSA) term to describe the effect of long-r...

متن کامل

Correlations and Predictions of THF + 2-Alkanol Binary Mixtures Behaviour by PC-SAFT Model and Friction Theory

In this article the behavior of tetrahydrofuran (THF) + 2-alkanol namely 2-propanol, 2-butanol, 2-pentanol, 2-hexanol and 2-heptanol binary mixtures through the density and viscosity measurements have been studied as a function of composition and within the temperature range of 293.15–313.15 K. The excess molar volume, isobaric thermal expansivity, partial molar volumes, and viscosity deviation...

متن کامل

An Improved ISM Equation of State for Polar Fluids

We developed an equation of state (EOS) by Ihm, Song, and Mason (ISM) for polar fluids. The model consists of four parameters, namely, the second virial coefficient, an effective van der Waals co-volume, a scaling factor, and the reduced dipole moment. The second virial coefficient is calculated from a correlation that uses the heat of vaporization, and the liquid density at the normal boiling ...

متن کامل

Observations of Sludge Formation in Group I Base Stock for Lubricants and Thermodynamic Modeling with the SAFT Equation of State

Varnish and sludge formation are considered as one of the most common problems in lubrication and hydraulic systems. In order to simulate the condition of sludge formation, base stock lubricant (Group 1 API) has been selected and exposed to heat in a laboratory setup. Sludge formation process accelerated in the laboratory scale and solid liquid equilibrium data were extracted. Then solid-liquid...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Journal of chemical physics

دوره 131 20  شماره 

صفحات  -

تاریخ انتشار 2009