Ultrafine Particle Distribution and Chemical Composition Assessment during Military Operative Trainings
نویسندگان
چکیده
(1) Background: The assessment of airborne particulate matter (PM) and ultrafine particles (UFPs) in battlefield scenarios is a topic of particular concern; (2) Methods: Size distribution, concentration, and chemical composition of UFPs during operative military training activities (target drone launches, ammunition blasting, and inert bomb impact) were investigated using an electric low-pressure impactor (ELPI+) and a scanning electron microscope (SEM), equipped with energy-dispersive spectroscopy (EDS); (3) Results: The median of UFPs, measured for all sampling periods and at variable distance from sources, was between 1.02 × 10³ and 3.75 × 10³ particles/cm³ for drone launches, between 3.32 × 10³ and 15.4 × 10³ particles/cm³ for the ammunition blasting and from 7.9 × 10³ to 1.3 × 10⁴ particles/cm³ for inert launches. Maximum peak concentrations, during emitting sources starting, were 75.5 × 10⁶ and 17.9 × 10⁶ particles/cm³, respectively. Particles from the drone launches were predominantly composed of silicon (Si), iron (Fe) and calcium (Ca), and those from the blasting campaigns by magnesium (Mg), sulphur (S), aluminum (Al), iron (Fe), barium (Ba) and silicon (Si); (4) Conclusions: The investigated sources produced UFPs with median values lower than other anthropogenic sources, and with a similar chemical composition.
منابع مشابه
Effect of Particle Size Distribution and Chemical Composition on Properties of Magnesia Chromite Bricks
The present study was undertaken to improve the quality and increase the life time of magnesia-chromite refractory bricks used in the copper and lead industries. The results show that a decrease in the amount of large chromite particles in the formulation improves the thermomechanical properties and also reduces the slag penetration in the bricks. In addition it was also observed that the use o...
متن کاملUltrafine Particle (UFP) Exposures in an Aluminium Smelter: Soderberg vs. Prebake Potrooms
The objectives of this work were to evaluate ultrafine particle (UFP) exposures during aluminium smelting in Soderberg and prebake potrooms. Particle concentrations were monitored using the P-Trak 8525 and aerosol particle size distributions were monitored with the electrical low pressure impactor (ELPI). UFP samples were analyzed for chemical composition by transmission electron microscopy (TE...
متن کاملChallenges and Approaches for Developing Ultrafine Particle Emission Inventories for Motor Vehicle and Bus Fleets
Motor vehicles in urban areas are the main source of ultrafine particles (diameters < 0.1 μm). Ultrafine particles are generally measured in terms of particle number because they have little mass and are prolific in terms of their numbers. These sized particles are of particular interest because of their ability to enter deep into the human respiratory system and contribute to negative health e...
متن کاملIdentification and quantification of particle growth channels during new particle formation
Atmospheric new particle formation (NPF) is a key source of ambient ultrafine particles that may contribute substantially to the global production of cloud condensation nuclei (CCN). While NPF is driven by atmospheric nucleation, its impact on CCN concentration depends strongly on atmospheric growth mechanisms since the growth rate must exceed the loss rate due to scavenging in order for the pa...
متن کاملHuman pulmonary responses to experimental inhalation of high concentration fine and ultrafine magnesium oxide particles.
Exposure to air polluted with particles less than 2.5 micron in size is associated epidemiologically with adverse cardiopulmonary health consequences in humans. The goal of this study was to characterize human pulmonary responses to controlled experimental high-dose exposure to fine and ultrafine magnesium oxide particles. We quantified bronchoalveolar lavage (BAL) cell and cytokine concentrati...
متن کامل