Sintering of Al2O3–Ceo2nanopowder Prepared by Co-Precipitation Method

نویسنده

  • S. A. Hassanzadeh-Tabrizi
چکیده

In the present work, Al2O3-CeO2 composite nanopowders were synthesized via co-precipitation method. The sinterability of the synthesized powders was investigated. The results showed that the transformation of transition phases of alumina to α-Al2O3 takes place at 1200 °C. TEM images showed that the powders was composed of nanoparticles in the range of 30−70 nm. The densification of composites started at about 1200 °C. The relative density of sintered Al2O3-CeO2 composites was measured to be 95% at 1600 °C. SEM results of sintered samples showed a sub-micronic/ micronic microstructure.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Synthesis of MgTiO3 Powder Via Co-Precipitation Method and Investigation of Sintering Behavior

A co-precipitation method was used for synthesis of pure MgTiO3 ceramic powder with Mg(NO3)2.6H2O, TiCl4 or C12H28O4Ti and NaOH as raw materials. In this method, solutions of 1 M, Mg (NO3)2 6H2O and 2 M, NaOH were prepared. A stoichiometric amount of Ti precursors from TiCl4 or C12H28O4Ti was weighted. Solutions of Mg (NO3)2. 6H2O and Ti precursor were added dropwise to NaOH solution unde...

متن کامل

A comparative study on the dispersion of CuO-ZnO-Al2O3 nanoparticles over HZSM-5 via batch co-precipitation, semibatch co- precipitation and combined co-precipitation-ultrasound methods

A series of CuO-ZnO-Al2O3 nanoparticles over HZSM-5 were successfully prepared using different methods of batch co-precipitation, semibatch co-precipitation and combined co-precipitation-ultrasound. Nitrates of copper, zinc and aluminum were used as precursors, while Na-ZSM-5 was employed as composite support and sodium carbonate was used as precipitant agent. The effects of preparation methods...

متن کامل

PREPARATION AND SINTERING OF W-20%Wt Cu COMPOSITE POWDERS PRODUCED BY CO-PRECIPITATION METHOD

Abstract: materials can be fabricated by sintering of W-Cu composite powders. In this research W-20%wt Cu composite powderswas synthesized via a co-precipitation method. Precipitate obtained from a mixture of copper nitrate and ammoniumparatungstate (APT) in distilled water contained W-Cu compounds. This precipitate was washed, dried and calcinedat 550 of dried precipitate powder was determined...

متن کامل

Ultrasonic–Assisted Co–Precipitation Method of Preparation of Nanocomposites in The Al2O3–TiO2–ZrO2 System: Characterization and Microsturcture

Recently, the Al2O3–TiO2–ZrO2 system has found valuable applications, particularly, as a support for NOx storage–reduction (NSR) catalysts. Nanocomposite powders were prepared from the co-precipitation method in inorganic precursors. The behaviors of mixed oxide nanoparticles under ultrasonic irradiation, such as dispersion, and crushing were studied. Phase transformations, crystallite size, an...

متن کامل

SYNTHESIS OF AL2O3-NI COMPOSITE POWDERS BY CO-PRECIPITATION METHOD

The synthesis of micro-sized, uniformly distributed Al2O3-15Vol% Ni powders were studied through three step co-precipitation of hydroxides mixtures from proper solution, calcination at air atmosphere and final step of calcined powders in a carbon bed. Al and Ni hydroxide and amorphous phase were first obtained from their salt’s solutions through chemical co-precipitation method by adjusti...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2015