Fogging Control on LDPE/EVA Coextruded Films: Wettability Behavior and Its Correlation with Electric Performance
نویسندگان
چکیده
The transformation of fog at a non-visible water layer on a membrane of low-density polyethylene (LDPE) and ethylene-vinyl acetate (EVA) was evaluated. Nonionic surfactants of major demand in the polyolefin industry were studied. A kinetic study using a hot fog chamber showed that condensation is controlled by both the diffusion and permanency of the surfactant more than by the change of the surface energy developed by the wetting agents. The greatest permanency of the anti-fog effect of the LDPE/EVA surface was close to 3000 h. The contact angle results demonstrated the ability of the wetting agent to spread out to the surface. Complementarily, the migration of nonionic surfactants from the inside of the polymeric matrix to the surface was analyzed by Fourier transform infrared (FTIR) microscopy. Additionally, electrical measurement on the anti-fogging membrane at alternating currents and at a sweep frequency was proposed to test the conductivity and wetting ability of nonionic surfactants. We proved that the amphiphilic molecules had the ability to increase the conductivity in the polyolefin membrane. A correlation between the bulk electrical conductivity and the permanency of the fogging control on the LDPE/EVA coextruded film was found.
منابع مشابه
Dependence of Resistivity in Low-Density Polyethylene on Space Environment Parameters
The conductivity of high-resistivity polymer films is dependent on the magnitude of applied electric field, repeated electric field exposure, and sample temperature. A traditional constant voltage method was used, maintained under vacuum to more closely resemble the space environment. Both the strength of the applied voltage and the thickness of low-density polyethylene (LDPE) samples were vari...
متن کاملOxygen-barrier films based on low-density polyethylene/ ethylene vinyl alcohol/ polyethylene-grafted maleic anhydride compatibilizer
In this research, high oxygen-barrier films were organized based on low-density polyethylene (LDPE)/ ethylene vinyl alcohol (EVOH)/ polyethylene-grafted maleic anhydride (LDPE-g-MA) compatibilizer. The effects of 10–30 wt. % EVOH and 0–10 wt. % LDPE-g-MA loadings on the properties of final films were evaluated. The morphology of specimens was observed by using scanning electron microscopy (SEM)...
متن کاملThe effects of surface wettability on the fog and dew moisture harvesting performance on tubular surfaces.
The efficient water harvesting from air-laden moisture has been a subject of great interest to address world-wide water shortage issues. Recently, it has been shown that tailoring surface wettability can enhance the moisture harvesting performance. However, depending on the harvesting condition, a different conclusion has often been reported and it remains unclear what type of surface wettabili...
متن کاملCharacterization of nano-biocomposite films reinforced with nanofibrillated cellulose and montmorillonite as a potential application for Food packaging industry
In this study, polyvinyl alcohol- Nanofibrillated cellulose –Montmorillonite (PVA-NFC-MMT)and Ethylene-vinyl acetate- Nanofibrillated cellulose –Montmorillonite (EVA-NFC-MMT) nanocompositescontaining 2% weight of NFC and MMT were prepared by melt blending method. Then, the effect ofNFC and MMT as reinforcing materials on biodegradability, morphology, and mechanical, thermal an...
متن کاملCharacterizing films of polyethylene blends: An application of colorimetric parameters measurements
This study reports an application of instrumental color measurement for quantifying and comparing the optical properties of high density polyethylene HDPE and low density polyethylene LDPE blend films and the effect of blending ratio and miscibility on these properties. The technique of spectrophotometry in transmission and reflectance modes can be used as a versatile tool to evaluate the color...
متن کامل