Electrical Double-Layer Structure at the Rutile-Water Interface as Observed in Situ with Small-Period X-Ray Standing Waves.
نویسندگان
چکیده
X-Ray standing wave (XSW) measurements were made of Rb and Sr adsorbed from aqueous solutions at the rutile (110)-water interface. These experiments were performed to address the extent to which direct measurements of electrical double-layer structure are possible. The experimental results show that the Bragg XSW technique, using small-period standing waves generated by Bragg diffraction from the substrate, can precisely measure ion locations within the condensed layer and the in situ partitioning of ions between the condensed and diffuse layers. Differences in condensed layer ion positions were observed for Sr ions (measured in situ) as compared with Rb ions (in situ) and also for Sr ions (ex situ). An additional constraint on the ex situ Sr site geometry was provided by polarization-dependent surface EXAFS measurements. Such measurements can provide important constraints for the development and verification of electrical double-layer theory especially as applied to ion adsorption at the solid-water interface. Copyright 2000 Academic Press.
منابع مشابه
Model-independent X-ray imaging of adsorbed cations at the crystal–water interface
We describe an approach to directly image three-dimensional elemental distributions at the crystal–liquid interface with 1 A spatial resolution. This method, based on the Fourier synthesis of X-ray standing wave data, is demonstrated by imaging the distribution of Sr2þ, Zn2þ and Y3þ adsorbed to the rutile (1 1 0)-water interface with no a priori assumptions. The approach resolves distinct sites...
متن کاملIon adsorption at the rutile-water interface: linking molecular and macroscopic properties.
A comprehensive picture of the interface between aqueous solutions and the (110) surface of rutile (alpha-TiO2) is being developed by combining molecular-scale and macroscopic approaches, including experimental measurements, quantum calculations, molecular simulations, and Gouy-Chapman-Stern models. In situ X-ray reflectivity and X-ray standing-wave measurements are used to define the atomic ar...
متن کاملEffect of Annealing Temperature on Structural, Electrical and Optical Properties of TiO2 Nanopowder
TiO2 nanopowder is prepared by simple sol-gel method using starting material as titanium isopropoxide with methanol and annealed at 600°C, 700°C and 800°C for 1 hour in air. X-ray diffraction pattern revealed the presence of both anatase and rutile phase in TiO2 specimens annealed at different temperatures. It is observed that the content of rutile phase and crystallite size increases with incr...
متن کاملX-Ray in-situ saturation monitoring, an aid to study relative permeability in water-wet carbonate rocks
The simultaneous flow of oil and water in porous media is described by relative permeability curves, mainly derived from laboratory experiments. Relative permeability is of paramount importance in predicting reservoir production performance and drive mechanisms and its value depends largely on the volume fraction of fluids present in the test samples. Nowadays X-ray scanners are one of the most...
متن کاملFabrication and Characterization of Rutile TiO2 Nanocrystals by Water Soluble Precursor
In this research, TiO2 nanoparticles were synthesized by a simple wet chemical method. TiCl4 was used as precursor in hydrogen peroxideand ethanol. The TiO2 nanoparticles were characterized by transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray diffraction (XRD), electron dispersive spectroscopy (EDS) and UV-Vis spectrophotome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of colloid and interface science
دوره 225 1 شماره
صفحات -
تاریخ انتشار 2000