A Study of the Influence of L-Cut on Resistance of Chip Resistor Based on Finite Element Method
نویسنده
چکیده
The resistance increase by transverse cutting is more quickly than by ordinate cutting when using laser trimming. Therefore, the precision and efficiency of laser trimming can be improved at low cost through reasonable design of the L-cut. In this paper, the finite element method is used to study the influence of L-cut on the resistance of chip resistor. Experiments proved that the qualitative and quantitative conclusions of the influence of L-cut on the resistance obtained by the finite element method are consistent with the experimental results. Thus, using the conclusions of the influence of L-cut on the resistance obtained by the finite element method can provide the control basis for improving the trimming precision and trimming efficiency. Copyright © 2013 IFSA.
منابع مشابه
Chip Formation Process using Finite Element Simulation “Influence of Cutting Speed Variation”
The main aim of this paper is to study the material removal phenomenon using the finite element method (FEM) analysis for orthogonal cutting, and the impact of cutting speed variation on the chip formation, stress and plastic deformation. We have explored different constitutive models describing the tool-workpiece interaction. The Johnson-Cook constitutive model with damage initiation and damag...
متن کاملInvestigation of Crack Resistance in Single Walled Carbon Nanotube Reinforced Polymer Composites Based on FEM
Carbon nanotube (CNT) is considered as a new generation of material possessing superior mechanical, thermal and electrical properties. The applications of CNT, especially in composite materials, i.e. carbon nanotube reinforced polymer have received great attention and interest in recent years. To characterize the influence of CNT on the stress intensity factor of nanocomposites, three fracture ...
متن کاملA study on behavior of block pavement using 3D finite element method
Three dimensioned finite element analysis were conducted on concrete block paving. In order to verify the calculated results, an experimental case study was analyzed. Good agreement was observed between the measured and the calculated results. Based on the finite element analysis results and available failure models, comprehensive design charts were developed for port and industrial pavement wh...
متن کاملMechanical Buckling Analysis of Composite Annular Sector Plate with Bean-Shaped Cut-Out using Three Dimensional Finite Element Method
In this paper, mechanical buckling analysis of composite annular sector plates with bean shape cut out is studied. Composite material sector plate made of Glass-Epoxy and Graphite-Epoxy with eight layers with same thickness but different fiber angles for each layer. Mechanical loading to form of uniform pressure loading in radial, environmental and biaxial directions is assumed. The method used...
متن کاملStudy of Stone-wales Defect on Elastic Properties of Single-layer Graphene Sheets by an Atomistic based Finite Element Model
In this paper, an atomistic based finite element model is developed to investigate the influence of topological defects on mechanical properties of graphene. The general in-plane stiffness matrix of the hexagonal network structure of graphene is found. Effective elastic modulus of a carbon ring is determined from the equivalence of molecular potential energy related to stretch and angular defor...
متن کامل