Nonlinear beam self-cleaning in a coupled cavity composite laser based on multimode fiber.
نویسندگان
چکیده
We study a coupled cavity laser configuration where a passively Q-switched Nd:YAG microchip laser is combined with an extended cavity, including a doped multimode fiber. For appropriate coupling levels with the extended cavity, we observed that beam self-cleaning was induced in the multimode fiber thanks to nonlinear modal coupling, leading to a quasi-single mode laser output. In the regime of beam self-cleaning, laser pulse duration was reduced from 525 to 225 ps. We also observed a Q-switched mode-locked operation, where spatial self-cleaning was accompanied by far-detuned nonlinear frequency conversion in the active multimode fiber.
منابع مشابه
Kerr self-cleaning of pulsed beam in an ytterbium doped multimode fiber.
We experimentally demonstrate that Kerr spatial self-cleaning of a pulsed beam can be obtained in an amplifying multimode optical fiber. An input peak power of 500 W only was sufficient to produce a quasi-single-mode emission from the double-clad ytterbium doped multimode fiber (YMMF) with non-parabolic refractive index profile. We compare the self-cleaning behavior observed in the same fiber w...
متن کاملHigh energy, single-mode, narrow-linewidth fiber laser source using stimulated Brillouin scattering beam cleanup.
We propose an original nonlinear beam cleaning fiber laser architecture to obtain high energy pulses with a good beam quality and a narrow linewidth. The output beam of a large core Er:Yb co-doped multimode fiber amplifier (M(2) approximately 6, 220 microJ) is converted into a near diffraction limited beam (M(2) = 1.6) through a stimulated Brillouin scattering injection seeded beam cleanup proc...
متن کاملTransverse mode selection in laser resonators using volume Bragg gratings
Power scaling of high power laser resonators is limited due to several nonlinear effects. Scaling to larger mode areas can offset these effects at the cost of decreased beam quality, limiting the brightness that can be achieved from the multi-mode system. In order to improve the brightness from such multi-mode systems, we present a method of transverse mode selection utilizing volume Bragg grat...
متن کاملRefractive beam shapers for material processing with high power single mode and multimode lasers
The high power multimode fiber-coupled laser sources, like solid state lasers or laser diodes as well as single mode and multimode fiber lasers, are now widely used in various industrial laser material processing technologies like metal or plastics welding, cladding, hardening, brazing, annealing. Performance of these technologies can be essentially improved by varying the irradiance profile of...
متن کاملComposite Cavity Fiber Laser with Asymmetric Output Intensity and Wavelength
The composite cavity fiber laser (CCFL) is relatively simple in its fabrication, as it is essentially three wavelength matched Bragg gratings in a section of doped fiber. By using internal feedback with unequal sub-cavity lengths, unidirectional CCFLs with significantly asymmetric output power from its two outputs can be achieved. Preliminary results also show that it is possible for the lasing...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics express
دوره 25 19 شماره
صفحات -
تاریخ انتشار 2017