Design and Performance of Ssrl Beam Position Electronics*
نویسندگان
چکیده
SSRL designed and built beam position electronics for its SPEAR storage ring. We designed the electronics, using digital receiver technology, for highly accurate turn by turn measurements of both the position and arrival time of the beam, allowing us to use this system to measure the betatron and synchrotron tunes of the beam. The dynamic range of the system allows us to measure the properties of the beam at currents ranging from those of single bunch injection to those of the full SPEAR stored beam. This paper discusses the architecture of the electronics, presents their performance specifications, and shows a range of applications of this system for accelerator physics experiments.
منابع مشابه
The Stanford Synchrotron Radiation Laboratory - 20 Years of Synchrotron Light-
The Stanford Synchrotron Radiation Laboratory (SSRL) is now operating as a fully dedicated light source with low emittance electron optics, delivering high brightness photon beams to 25 experimental stations six to seven months per year. On October 1,1993 SSRL became a Division of the Stanford Linear Accelerator Center, rather than an Independent Laboratory -of Stanford University, so that high...
متن کاملSpear 3 - a Low Emittance Source for Ssrl*
SSRL is planning to upgrade the 3 GeV SPEAR storage ring in FY 2002 to reduce the emittance from 160 nm-rad to 18 nm-rad and to increase the beam current from 100 to 200 mA, and then towards 500 mA as photon beam lines are upgraded. The core of the ’SPEAR 3’ project includes new magnets and power supplies for a DBA lattice, vacuum chamber, and a modedamped RF cavity system. Beam lines will see ...
متن کاملStatus of Digital Orbit Feedback for Spear
* Work supported in part by Department of Energy Contract DE-AC03-76SF00515 and Office of Basic Energy Sciences, Division of Chemical Sciences. ABSTRACT The present global orbit feedback system for SPEAR can adjust the electron beam position with a cycle time of 5 s. In addition, 50 Hz analog local servos stabilize the vertical photon beam position at monitors situated in the ten SSRL beamlines...
متن کاملFuzzy PD Cascade Controller Design for Ball and Beam System Based on an Improved ARO Technique
The ball and beam system is one of the most popular laboratory setups for control education. In this paper, we design a fuzzy PD cascade controller for a ball and beam system using Asexual Reproduction Optimization (ARO) technique. The ball & beam system consists of a servo motor, a grooved beam, and a rolling ball. This system utilizes a servo motor to control ball’s position on the beam. Chan...
متن کاملOptimization Capabilities of LMS and SMI Algorithm for Smart Antenna Systems (RESEARCH NOTE)
In the present paper convergence characteristics of Sample matrix Inversion (SMI) and Least Mean Square (LMS) adaptive beam-forming algorithms (ABFA) are compared for a Smart Antenna System (SAS) in a multipath environment. SAS are employed at base stations for radiating narrow beams at the desired mobile users. The ABFA are incorporated in the digital signal processors for adjusting the weight...
متن کامل