Deemo: a New Technology for the Fabrication of Microstructures
نویسنده
چکیده
The recent innovations in dry etching make it a promising technology for the fabrications of micromoulds. The high aspect ratios, directional freedom, low roughness, high etch rates and high selectivity with respect to the mask material allow a versatile fabrication process of micromoulds for subsequent electroplating and embossing, as is demonstrated with the DEEMO process. DEEMO is an English acronym and stands for Dry Etching, Electroplating and Moulding.
منابع مشابه
Cold Sintering Process: New sintering technique for fabrication of nano-structured ceramics below 300 °C - A review
Due to the conventional understanding of sintering phenomenon in ceramic materials, considering two words of “cold” and “sintering” together may arise a doubt to a ceramic engineer since the usual sintering process has been accompanied by a heating regime at elevated temperatures. Recently, a new technique called Cold Sintering Process (CSP) has been introduced and developed as an ultra-low tem...
متن کاملAn Overview of Fabrication Methods and Applications of Carbon Nanotube Membrane in Environmental Engineering as Hydraulic Microstructures
The main purpose of this article is to study fabrication methods and applications of aligned carbon nanotube (CNT) membranes as a hydraulic microstructure in treatment processes. This paper emphasizes the use of CNTs as membrane in separation processes like water and wastewater treatment because of their exclusive advantages. Their most important characteristics are high mechanical strength aga...
متن کاملDesign and Fabrication of a Narrow-bandwidth Micromechanical Ring Filter using a Novel Process in UV-LIGA Technology
This paper presents the design and a new low-cost process for fabrication of a second-order micromechanical filter using UV-LIGA technology. The micromechanical filter consists of two identical bulk-mode ring resonators, mechanically coupled by a flexural-mode beam. A new lumped modeling approach is presented for the bulk-mode ring resonators and filter. The validity of the analytical derivatio...
متن کاملOut-of-plane microstructures using stress engineering of thin films
A new method is presented to fabricate out-of-plane microstructures using traditional planar micromachining technology. Composite LPCVD polysilicon/silicon nitride beams are fabricated to study this concept. Polysilicon films ranging from 0.5 μm to 1.3 μm, and silicon nitride films ranging from 150 to 450 nm, were used to fabricate various thickness ratios of composite out-of-plane microstructu...
متن کاملSintered Steel Composites Reinforced with Ceramic Nanoparticles: Fabrication, Characteristics and Wear Behavior
Steel composites reinforced with alumina nanoparticles were prepared by powder metallurgy process. Samples containing two different amounts of carbon (0.35 and 0.55 wt.%) and 0-5 wt.% Al2O3 nanoparticles were fabricated by mixing, compacting and sintering of diffusion bonded Distaloy AE powder. The density, hardness and wear tests were performed on the prepared samples. Fu...
متن کامل