Finite Element Modelling of Forging and Other Metal Forming Processes
نویسندگان
چکیده
The fundamental mechanical formulation is recalled for simulation of metal forming processes. The basic principles of 3-dimensional finite element discretization and of time integration are summarized. Several important numerical developments for efficient computation of large plastic deformation are briefly described. Various fields of applications to real processes are reviewed. Illustrative examples are mentioned to show the utilization of the commercial computer code Forge3 in industry, as a very flexible tool to design metal forming sequences.
منابع مشابه
International Journal of Emerging Technology and Advanced Engineering
There are a wide range of physical defects which occur during metal forming processes. These defects, which may occur on the surface or be internal, are undesirable not only because of the surface appearance, but because they may adversely affect the strength, formability and other manufacturing characteristics of the material. Some physical defects in metal forming processes such as rolling an...
متن کاملFinite E L E M E N T Analysis of Metal Forming Processes with Arbitrarily Shaped Dies
-A method of discretizing the die boundary conditions is considered for the analysis of metal forming processes by the rigid viscoplastic finite element method. The method is natural to the finite element method and general enough to treat the boundary conditions of arbitrarily shaped dies in a unified way. Solutions of the spike forging process are obtained by using the method. The deformation...
متن کاملFINITE ELEMENT PREDICTION OF DUCTILE FRACTURE IN AUTOMOTIVE PANEL FORMING: COMPARISON BETWEEN FLD AND LEMAITRE DAMAGE MODELS
In sheet metal forming processes with complex strain paths, a part is subjected to large plastic deformation. This severe plastic deformation leads to high plastic strain localization zones and subsequent accumulation of those strains. Then internal and superficial micro-defects and in other words ductile damage is created. This damage causes quality problems such as fracture. Therefore, design...
متن کاملThe Relationship between Constant Friction Factor and Coefficient of Friction in Metal Forming using Finite Element Analysis
Frictional shear stress is usually determined by utilizing the coefficient of friction or the constant friction factor models. The present study deals with finite element analysis of double cup extrusion process to determine the relationship between constant friction factor (m) and coefficient of friction (µ), since the metal flow in this process is very sensitive to frictional conditions. Ther...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, Buckling Limit of Strain (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when buck...
متن کامل