Parameter Estimation and Flying Qualities of a Twin-Engine CS23/FAR23 Certified Light Aircraft
نویسندگان
چکیده
This paper presents some results of the flight test campaign conducted on the Tecnam P2006T aircraft, on the occasion of its certification process. This twin-engine propeller airplane is certified under the normal category CS-23 and FAR 23. A prototype of this light aircraft has been tested in flight for a post-design performance optimization and for the assessment of flight qualities. These experiences have led to the application of two winglets to the original wing. The final configuration has been extensively tested for the achievement of CS-23 certification. At the same time the airplane model, through a dedicated set of flight maneuvers, has been characterized by means of parameter estimation studies. The longitudinal and lateral-directional response modes have been assessed and quantified. The aircraft stability derivatives have been estimated from the acquired flight data using the identification technique known as Output Error Method (OEM). Some estimated stability derivatives have been also compared with the corresponding values extracted from leveled flight tests and from wind tunnel tests performed on a scaled model of the aircraft.
منابع مشابه
In-flight modal analysis – a comparison between sweep and turbulence excitation
At the end of the development cycle, a new aircraft is certified by means of in-flight flutter tests. These tests consist of flying the aircraft at different airspeeds and measuring the accelerations at a limited number of locations on the aircraft structure. The scope is to open the flight domain by verifying that the aircraft does not suffer from aero-elastic instabilities such as flutter. In...
متن کاملFlying Qualities Constraints in the Multidisciplinary Design Optimization of a Supersonic Tailless Long Range Aircraft
The increased complexity of next generation aircraft has popularized Multidisciplinary Design Optimization (MDO) as an aircraft design tool. However, MDO efforts consistently neglect aircraft stability and control analyses beyond simple static assessments. Not only does this limit the potential of the MDO to identify an optimal design, but it also fails to assess the MIL-STD or FAR handling qua...
متن کاملAircraft Visual Identification by Neural Networks
In the present paper, an efficient method for three dimensional aircraft pattern recognition is introduced. In this method, a set of simple area based features extracted from silhouette of aerial vehicles are used to recognize an aircraft type from its optical or infrared images taken by a CCD camera or a FLIR sensor. These images can be taken from any direction and distance relative to the fly...
متن کاملAerodynamic Analysis and Design of a Twin Engine Commuter Aircraft
The present paper deals with the preliminary design of a general aviation Commuter 11 seat aircraft. The Commuter aircraft market is today characterized by very few new models and the majority of aircraft in operation belonging to this category are older than 35 years. Tecnam Aircraft Industries and the Department of Aerospace Engineering (DIAS) of the University of Naples "Federico II" are dee...
متن کاملSensor Selection Optimization for Aircraft Gas Turbine Engine Health Estimation
Sensor selection optimization can lead to significant improvements in the controllability and observability of a dynamic system. The aim of this research is to investigate optimal or alternate measurement sets for aircraft gas turbine engine health parameter estimation. A brute force search for the best sensor set is too computationally expensive. Therefore, a Monte Carlo approach is used to pe...
متن کامل