Modelling and simulation of twin - roll casting of bulk metallicglasses
نویسنده
چکیده
منابع مشابه
Dynamic Modeling of Twin-roll Steel Strip Casting
We consider the problem of dynamic coupling between the rapid thermal solidification and mechanical compression of steel in twin-roll steel strip casting. In traditional steel casting, molten steel is first solidified into thick slabs and then compressed via a series of rollers to create thin sheets of steel. In twin-roll casting, these two processes are combined, thereby making control of the ...
متن کاملMolten Steel Level Control of Strip Casting Process Monitoring by Using Self-Learning Fuzzy Controller
The twin-roll strip casting process is a typical steel-strip production method which combines continuous casting and hot rolling process. The production line from molten liquid steel to the final steel-strip is shortened and the production cost is reduced significantly compared to the conventional continuous casting. The twin-roll strip casting process can produce 1-5 mm thin steel strip direct...
متن کاملTEM Investigation of Precipitation in Al-Mn Alloys with Addition of Zr
Aluminium and its alloys belong to the most widely used metallic materials for industrial applications. One of the possible casting methods is twin-roll casting which produces sheets with high solid solution supersaturation. Decomposition of this supersaturated material during heat treatment was studied in aluminium alloys from the AW-3003 series – one standard grade and the other modified by a...
متن کاملSimulation of the Continuous Casting and Cooling Behavior of Metallic Glasses
The development of melt spinning technique for preparation of metallic glasses was summarized. The limitations as well as restrictions of the melt spinning embodiments were also analyzed. As an improvement and variation of the melt spinning method, the vertical-type twin-roll casting (VTRC) process was discussed. As the thermal history experienced by the casting metals to a great extent determi...
متن کاملFinite element simulation of pyroplastic deformation, anisotropic shrinkage and heterogeneous densification for ceramic materials during liquid phase sintering process
Pyroplastic deformation is a distortion of the ceramic shape during the sintering process. It occurs because the flow of the vitreous phase at high temperature and the applied stress due to the weight of the product during sintering process. The aim of this paper deals with describing a numerical-experimental method to evaluate the pyroplastic deformation, to predict the anisotropic shrinkage a...
متن کامل