A Novel Measurement System for the Common-Mode- and Differential-Mode-Conducted Electromagnetic Interference
نویسندگان
چکیده
Electromagnetic Interference (EMI) test is an important part for the manufacture of power electronic equipment, which helps us not only analyze the noise characteristics of the Equipment Under Test (EUT) but also design EMI filters. The previous separation method for the Common Mode (CM) and Differential Mode (DM) noise was time consuming or costly. In this paper, a novel measurement system for CM and DM conducted EMI is described showing a good performance. The system consists of two parts, part 1: getting CM noise or DM noise through a current probe; part 2: obtaining another mode noise from a software-based method. A 150w switch mode power supply is measured to verify the proposed measurement system. The noise spectra of CM and DM signal is shown, and the results obtained by software program are compared with those obtained from a current probe measurement showing a good concordance in terms of peak value.
منابع مشابه
A Novel Active Filter for Mitigation of EMI and Other Adverse Effects of PWM Inverter-Fed AC Motor
This paper presents novel active filter for mitigation electromagnetic interference (EMI) and other adverse effects of pulse width modulation (PWM) inverter-fed AC motor system. An active filter proposed and devised for this system is characterized by sophisticated connection of two small separate filters, capable of mitigating all the adverse effects. This paper provides high frequency models ...
متن کاملFully Differential Current Buffers Based on a Novel Common Mode Separation Technique
In this paper a novel common mode separation technique for implementing fully differential current buffers is introduced. Using the proposed method two high CMRR (Common Mode Rejection Ratio) and high PSRR (Power Supply Rejection Ratio) fully differential current buffers in BIPOLAR and CMOS technologies are implemented. Simulation results by HSPICE using 0.18μm TSMC process for CMOS based st...
متن کاملPractical Approach in Designing Conducted EMI Filter to Mitigate Common Mode and Differential Mode Noises in SMPS
Fast switching in SMPS generate large amount of Electromagnetic Interference (EMI). The EMI consists of mainly common mode and differential mode noises. In the present work, conducted EMI is studied and a procedure for designing AC power line filter is proposed. As an application of this design procedure, conducted EMI noise measurement and filter design of a boost AC-DC converter with PFC has ...
متن کاملAn Ultra High CMRR Low Voltage Low Power Fully Differential Current Operational Amplifier (COA)
this paper presents a novel fully differential (FD) ultra high common mode rejection ratio (CMRR) current operational amplifier (COA) with very low input impedance. Its FD structure that attenuates common mode signals over all stages grants ultra high CMRR and power supply rejection ratio (PSRR) that makes it suitable for mixed mode and accurate applications. Its performance is verified by HSPI...
متن کاملControlling Common-Mode Voltages in Multilevel Inverters
This paper proposes a novel method based on pulse width modulation techniques toreduce and control the common-mode voltage in three-phase multilevel inverters. Besides controllingthe common-mode voltage, this method is capable of controlling capacitors voltages and load currentswith low switching losses and harmonic contents. In fact, due to the existence of different pulsepatterns and the poss...
متن کامل